Turbocharger - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 检查涡轮增压器密封垫有无磨损或损坏。 如果涡轮增压器密封垫磨损或损坏,则用新件更换。
- 将 5P-3931 抗咬合剂 涂抹到涡轮增压器安装螺柱的螺纹上。
- 在排气歧管上定位涡轮增压器密封垫和涡轮增压器 (6) 。 安装将涡轮增压器 (6) 固定到排气歧管上的螺母 (4) 。
Show/hide table
图 1 | g00617565 |
- 上紧将涡轮增压器固定到排气歧管上的锁紧螺母。
将带有螺旋锁螺纹的 3E-8017 锁紧螺母 上紧到以下扭矩: ... 54 ± 5 N·m (40 ± 4 lb ft)
将标准 9X-6620 锁紧螺母 上紧到以下扭矩: ... 70 ± 5 N·m (50 ± 4 lb ft)
- 检查机油供应管组件 (5) 和管组件 (2) 的密封垫。 如果密封垫磨损或损坏,则用新件更换。
Show/hide table
图 2 | g00617515 |
- 将管组件 (2) 和密封垫定位到涡轮增压器 (6) 上。 将螺栓 (1) 安装到涡轮增压器上,并将螺栓 (3) 安装到缸体上。
- 为机油供应管组件 (5) 安装密封垫后将机油供应管组件 (5) 连接到涡轮增压器 (6) 上。
Caterpillar Information System:
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Ether Injection System
3126B and 3126E Truck Engine Fuel System - Prime
C-10 and C-12 Industrial Engines Connecting Rod Bearing Journal
3126B and 3126E Truck Engine Fuel System - Inspect
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0100 - FMI 02 (for EUI Engines)
TK711, TK721, TK722 and TK732 Track Feller Bunchers Operator Station
325, 325B and 325L Excavators Travel Motor
2000/06/01 Field Returns of the Engine Speed Sensor are Necessary for Failure Analysis and Product Improvement {1907}
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Engine Speed/Timing Sensor
G3516B Engines MID 036 - CID 0320 - FMI 03 Speed/Timing Sensor short to +batt
3126B Industrial Engine Coolant Temperature Switch - Test
2000/05/01 New Hydrax System Pressure Relief Valve Assembly With A Serviceable Relief Valve Used {1716}
3126B and 3126E Truck Engine Fuel System Pressure - Test
3126B Engines Gear Group (Front) - Time
325, 325B and 325L Excavators Travel Counterbalance Valve
325, 325B and 325L Excavators Oil Makeup (Travel System)
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Injector Solenoids
325, 325B and 325L Excavators Swivel
3126B Engines Inlet Manifold Pressure - Test
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Prelubrication System
3126B Engines Turbocharger - Inspect
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Excessive Valve Lash
2002/12/23 Use the 171-7212 Wear Sleeve to Repair the Crankshaft Hub {1160}
C12 Marine Engines Speed/Timing Sensor