Governor - Remove
Removal Procedure
Start By:
- Remove the governor control linkage. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove".
- Remove the front timing cover. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
 | |
| Illustration 1 | g00703783 |
- Remove four bolts (1) that attach governor weight assembly (2) to fuel injection pump gear (3) .
Show/hide table
 | |
| Illustration 2 | g00807953 |
(A) Location of the linkage in the front timing cover | |
- Remove the nut, spring washer, and flat washer (7) from shaft (8) .
Show/hide table
 | |
| Illustration 3 | g00807968 |
- Remove spring (4) from lever (5) .
- Remove lever (5) from shaft (8) .
- Remove bolt (13) from the side of the front timing cover.
- Remove two spring clips (11) that hold inner pin (10) and outer pin (12) in position.
- Remove governor control lever (6) and fuel control lever (9) from the front timing cover.
Caterpillar Information System:
G3406 Engine Refill Capacities
3126B and 3126E On-highway Engines Sensors and Electrical Connectors
325, 325B and 325L Excavators Travel Motor
SR4 HV and SR4B HV Generators Fire Prevention and Explosion Prevention
G3408 and G3412 Engines Valve Data Sheet
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Switch ON Lamp Circuit - Test
P16, P20, P25, P28, P40 and P60 Pulverizer Fire Prevention and Explosion Prevention
TK711, TK721, TK722 and TK732 Track Feller Bunchers Equipment Lowering with Engine Stopped
325, 325B and 325L Excavators Travel Motor
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>130-0234</B> Generator through <B>130-7595</B> Generator
G3300 Engines Burn Prevention
P16, P20, P25, P28, P40 and P60 Pulverizer Burn Prevention
3126E Engine for Combat and Tactical Vehicles Flash Programming
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>5N-8891</B> Generator through <B>5N-8911</B> Generator
G3408 and G3412 Engines Safety Messages
G3406 Engine Product Description
3500B Engines Exhaust Manifold
G3408 and G3412 Engines Product Description
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>5N-9081</B> Generator through <B>5N-9432</B> Generator
3412 Generator Set Engines Basic Engine
325, 325B and 325L Excavators Travel Counterbalance Valve
3034 Industrial Engine Governor - Install
C-10 and C-12 Engines Model View Illustrations
3500B Engines for Caterpillar Built Power Modules Engine Oil Pan