Recoil Spring
Show/hide table
Illustration 1 | g01940495 |
(1) Apply 4C-4030 Thread Lock Compound to the threads of the two bolts.
(2) Before assembly with the idler group, the surfaces must be clean and free of any protective coating.
(3) 239-4407 Spring
- Length under test force ... 845 mm (33.3 inch)
- Test force ... 25007 ± 1900 N (5620 ± 425 lb)
- Free length after test ... 978.59 mm (38.527 inch)
- Outside diameter ... 234.88 mm (9.247 inch)
- Test force ... 25007 ± 1900 N (5620 ± 425 lb)
(A) Installed length ... 845 mm (33.3 inch)
Caterpillar Information System:
3064 and 3066 Engines for Caterpillar Built Machines Exhaust Manifold
330D, 336D and 340D Excavators Hydraulic System Hydraulic Oil Cooler
330B Excavator Machine System Specifications Front Idler
C6.6 Engines for Caterpillar Built Machines Starter Motor
C15 Engine for the 657G Wheel Tractor-Scraper Ether Injection System - Test
M325D and M330D Excavators Power Train Electronic Control System Electronic Control Module (ECM) - Configure
3064 and 3066 Engines for Caterpillar Built Machines Cylinder Head - 3066
M325D and M330D Excavators Power Train Electronic Control System Calibration
2006/01/02 Troubleshooting Engines with Mechanical Unit Injection (MUI) {1254}
C6.6 Engines for Caterpillar Built Machines Flywheel Housing
C6.6 Engines for Caterpillar Built Machines Cylinder Head Valves
2006/03/20 New Turbochargers are Now Used {1052}
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 10 Intake Manifold Pressure Signal abnormal rate of change
Fast Fill System-Fuel {1273, 1279, 1710} Fast Fill System-Fuel {1273, 1279, 1710}
320D and 323D Excavators Machine System Specifications Boom Cylinder
320D and 323D Excavators Machine System Specifications Stick Cylinder
2006/01/30 Installation Instructions for the Grease Fittings on Hydraulic Hammers {6333}
C11 and C13 Engines Engine Oil Pressure Sensor
2006/01/23 Proper Identification of Ports on 5P-0306 Vacuum Transducer {0768, 5050, 5056}
2006/02/13 Disposable Dessicant Filter is Now Available {0618, 0646}
Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264} Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264}
2006/04/24 A Conical Bumper Has Been Added for the Alignment of the Rear Hood on Mini Hydraulic Excavators {1051, 7251}
2006/01/30 Improved Air Conditioning Circulation on Excavator {7251, 7276}
303.5C and 303C Mini Hydraulic Excavators Machine Systems Pilot Valve (Boom Swing) - Disassemble