C15 Petroleum Generator Set Engines Caterpillar


Alternator and Regulator

Usage:

C15 115


图 1g02562817

表 1
5N-5692 充电交流发电机总成的技术规格 
项目  数量  零件  技术规格说明 
连接蓄电池与碳堆 4C-4911 蓄电池负载测试仪以便达到最大交流发电机输出。 
拧紧交流发电机安装螺栓前,先拧紧螺栓。 
拧紧至扭矩为 88.4 ± 6.8 N·m (65.0 ± 5.0 lb ft)
187-2034 法兰螺母  拧紧至扭矩为 102 ± 7 N·m (75 ± 5 lb ft)。 
6V-8187 螺母  (B+) 端子采用 7/16 接线柱。 
(B+) 端子。 拧紧至扭矩为 6.2 ± 0.6 N·m (55.0 ± 5.0 lb in)
(R) 接线端的峰值电压必须不低于 (B+) 接线端的输出电压。 
(B-) 端子。 拧紧至扭矩为 2.25 ± 0.25 N·m (20.00 ± 2.00 lb in)。 
电压为 24 V。 
电流为 45 安培。 
极性为负极接地。 
可朝顺时针或逆时针方向转动。 
最大接通转速为 2500 rpm 
25 °C (77 °F) 时的交流发电机性能 
5000 rpm 时的最小满载电流为 42.3 安培。 
2000 rpm 时的最小满载电流为 15.8 安培。 
输出电压为 28 ± 1 V。 

Caterpillar Information System:

325D and 329D Excavators Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
365C Excavator Machine Systems Swivel - Install
365C Excavator Machine Systems Swivel - Remove
303C CR, 303.5C CR, 304C CR and 305C CR Mini Hydraulic Excavators Hydraulic System Oil - Change
M318C and M322C Excavators Machine Systems Hydraulic Tank and Filter - Install
M318C and M322C Excavators Machine Systems Hydraulic Tank and Filter - Remove
Pin Grabber Quick Hitch Plate Locations and Film Locations
365C Excavator Machine Systems Oil Filter (Hydraulic, Return) - Install
365C Excavator Machine Systems Oil Filter (Hydraulic, Return) - Remove
2007/09/03 Replacement of the 223-3383 Washer Pump As on Certain Motor Graders and Track-Type Tractors {7306}
302.5C Mini Hydraulic Excavator Machine Systems Bucket Cylinder - Remove and Install
365C Excavator Machine Systems Pedal Control (Travel) - Install
3126B Engine for Caterpillar Built Machines Coolant in Engine Oil
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
302.5C Mini Hydraulic Excavator Machine Systems Final Drive and Travel Motor - Remove
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
302.5C Mini Hydraulic Excavator Machine Systems Final Drive and Travel Motor - Install
304C and 305C Mini Hydraulic Excavators Machine Systems Load Control Valve (Boom Cylinder) - Remove and Install
365C Excavator Machine Systems Swing Control Valve - Remove
365C Excavator Machine Systems Swing Control Valve - Install
390D Excavator Machine Systems Cab - Remove
390D Excavator Machine Systems Cab - Install
2005/12/05 Improved Valve Springs are Now Used {1100, 1108}
325D and 329D Excavators Hydraulic System Relief Valve (Swing) - Test and Adjust
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.