Travel Alarm - Test
You must move the machine in order to test the travel alarm.
- Start the engine. Lower the hydraulic lockout control to the UNLOCKED position.
- Raise the work tool. Make sure that there is adequate overhead clearance.
Show/hide table
Illustration 1 g01171530 - Use the travel levers to move the machine forward. The travel alarm should sound.
- Release the travel levers in order to stop the machine.
- Use the travel levers to move the machine backward. The travel alarm should sound.
- Release the travel levers in order to stop the machine. Lower the work tool to the ground. Deactivate the hydraulic controls by placing the hydraulic control console in the RAISED position. Stop the engine.
Caterpillar Information System:
C4.4 Industrial Engine Engine Starting
C4.4 Industrial Engine Burn Prevention
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Pilot Valve (Joystick) - Remove
Replacing Tooth Holders on the Rotary Cutter Drum for the HM312 and HM315{0751, 6638} Replacing Tooth Holders on the Rotary Cutter Drum for the HM312 and HM315{0751, 6638}
2014/08/01 A New Fuel Transfer Pump Has Been Released {1256}
325C LCR Excavator Machine Systems Platform - Install
C9 Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Boom and Stick Linkage - Lubricate
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Blade Linkage - Lubricate
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Cab Air Filter (Fresh Air) - Clean/Replace
M313C and M315C Excavators Joystick Controls
301.6C and 301.8C Mini Hydraulic Excavators Hydraulic System Main Hydraulic System
M325D MH Material Handler Monitoring System
M325D MH Material Handler Storage and Literature Compartment
M325D MH Material Handler Cab Door
M318C and M322C Excavators Engine Supplement Electric Starting Motor - Remove and Install
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Tip-Over Protective Structure (TOPS) - Inspect
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Pilot Valve (Joystick) - Install
325D and 329D Excavators Hydraulic System Swivel
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Swing Frame and Cylinder Bearings - Lubricate
302.5C Mini Hydraulic Excavator Machine Systems Pilot Valve (Joystick) - Disassemble
302.5C Mini Hydraulic Excavator Machine Systems Pilot Valve (Joystick) - Assemble
Supplemental Product Support Literature for a Factory Installed 20 kW Right Front Corner Mounted Generator Set ( 247-5442 Hydraulic Generator Arrangement) and the Operation Instructions {1404, 1408, 4450, 5057, 5070, 7000} Supplemental Product Support Literature for a Factory Installed 20 kW Right Front Corner Mounted Generator Set ( 247-5442 Hydraulic Generator Arrangement) and the Operation Instructions {1404, 1408, 4450, 5057, 5070, 7000}
302.5C Mini Hydraulic Excavator Machine Systems Gear Pump (Pilot) - Disassemble