Fuel Pressure - Diesel System
Show/hide table
参数 | 值 |
燃油歧管压力 | |
输油泵压力 | |
使用此步骤检查调节后的燃油压力。
Show/hide table
所需工具 | |
数量 | 零件号 |
1 | 1U-5470 发动机压力表总成 |
Show/hide table
图 1 | g01192577 |
1U-5470 发动机压力表总成 (1) 压力指示器 (2) 零位调整螺钉 (3) 压力指示器 (4) 测压口 (5) 压力指示器 |
此工具总成具有用于读取燃油歧管压力的压力表。 此工具总成附带一本专门说明书, GMGO8907。
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
注意 |
---|
不要让脏物进入燃油系统。 彻底清洁将要拆开的燃油系统部件的周围区域。 在拆开的燃油系统部件上安放适当的盖。 |
Show/hide table
注意 |
---|
使用适当的容器来盛接可能溅出的燃油。 立即清理所有溅溢的燃油。 |
Show/hide table
图 2 | g00284797 |
燃油歧管和油管 (6) 通向缸盖的供油管 (7) 燃油歧管 |
- 关闭发动机
- 将 T 形管接头安装到燃油管 (6) 中。 将 1U-5470 发动机压力总成连接到 T 形管接头。 参考图2 。
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
注意 |
---|
不要让脏物进入燃油系统。 彻底清洁将要拆开的燃油系统部件的周围区域。 在拆开的燃油系统部件上安放适当的盖。 |
Show/hide table
注意 |
---|
使用适当的容器来盛接可能溅出的燃油。 立即清理所有溅溢的燃油。 |
Show/hide table
图 3 | g00284797 |
燃油歧管和油管 (6) 通向缸盖的供油管 (7) 燃油歧管 |
- 关闭发动机
- 将 T 形管接头安装到燃油管 (6) 中。 将 1U-5470 发动机压力总成连接到 T 形管接头。 参考图2 。
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
注意 |
---|
不要让脏物进入燃油系统。 彻底清洁将要拆开的燃油系统部件的周围区域。 在拆开的燃油系统部件上安放适当的盖。 |
Show/hide table
注意 |
---|
使用适当的容器来盛接可能溅出的燃油。 立即清理所有溅溢的燃油。 |
- 关闭发动机。
Show/hide table
图 4 g01290055 燃油输油管路和燃油滤清器管路。
(8) 通向注油泵的进油管
(9) 塞
(10) 从燃油滤清器到燃油歧管的油管(已过滤的机油)
(11) 燃油注油泵适配器
(12) 来自输油泵的燃油管
(13) 燃油滤清器 - 慢慢松开螺塞 (9)。 参考图 4。
- 将 1U-5470 发动机压力总成连接到测压口 (9) 中。
- 起动发动机
- 在额定转速和负载下运转发动机。
- 记录压力读数。
如果压力不在技术规格范围内,参考故障诊断与排除, "燃油压力过低"
Caterpillar Information System:
3126B Engines Exhaust Temperature - Test
2000/02/01 Correction to Specifications Module, SENR6557-01, "3100 HEUI Diesel Truck Engine" {1105}
3512B Marine Auxiliary Engine Engine Speed/Timing Sensor - Remove and Install
3500B and 3500B High Displacement Generator Set Engines Monitoring System Parameters
2004/08/02 New Cab Air Filters Provide Improved Efficiency and Odor Reduction {7309, 7320, 7342}
3500B and 3500B High Displacement Generator Set Engines Calibration
2000/02/01 Check The 163-3266 Time Delay Relay If There Is An Unexplained Engine Shutdown {7451}
3500B Locomotive Engines System Configuration Parameters
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Engine Design
Alternator - Delco 27SI Charging System
HDB Series and M1 Series Heavy Duty Brushless Alternators General Information
3408E and 3412E Engines for Caterpillar Built Machines Electrical System
3126B Engines Aftercooler - Test
3524B Engines for 797 and 797B Off-Highway Trucks Camshaft Timing
Installation Instructions for Piston Packs{1225, 1239} Installation Instructions for Piston Packs{1225, 1239}
3126B Engines Engine Crankcase Pressure (Blowby) - Test
3524B Engines for 797 and 797B Off-Highway Trucks Fuel Injector Adjustment
3126B Engines Engine Valve Lash - Inspect/Adjust
3412E and C30 Marine Engines Overhaul (Top End)
3408E and 3412E Engines for Caterpillar Built Machines Fuel System - Inspect
The Installation of an ADEM 2000 on C-10, C-12, 3406E, C-15, or C-16 Truck Engines into a 1998 and Earlier Model ADEM ll on C-10, C-12, or 3406E Chassis{1000, 1408, 1901, 1920} The Installation of an ADEM 2000 on C-10, C-12, 3406E, C-15, or C-16 Truck Engines into a 1998 and Earlier Model ADEM ll on C-10, C-12, or 3406E Chassis{1000, 1408, 1901, 1920}
Procedure For Replacing The Software For The Timing Control Module{1901} Procedure For Replacing The Software For The Timing Control Module{1901}
2000/02/01 C-10 and C-12 Low Oil Pressure Warnings {1924}
3408E and 3412E Engines for Caterpillar Built Machines Fuel System - Prime