CID 1603 FMI 09 Machine Control Module not communicating on link
Conditions Which Generate This Code:
The Electronic Control Module (ECM) cannot detect communication with the machine control module.
System Response:
The ECM will log the diagnostic code. All features that rely on the data link are disabled.
- There are no performance effects.
Test Step 1. Perform the following diagnostic procedure: Cat Data Link Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C27 and C32 Generator Set Engines CID 1785 FMI 10 Intake Manifold Pressure Signal abnormal rate of change
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 04 Intake Manifold Pressure Sensor voltage low
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 03 Intake Manifold Pressure Sensor voltage high
330C Excavator Hydraulic System Specifications
330C Excavator Hydraulic System Gear Pump (Fan Motor) - Test
330C Excavator Hydraulic System Gear Pump (Pilot) - Test
330C Excavator Hydraulic System Pump Control (Negative Flow) - Adjust
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers CID 1603 FMI 12 Machine Control Module malfunction
330C Excavator Hydraulic System Pump Control (Negative Flow) - Test
330C Excavator Hydraulic System Pump Control (Output Flow) - Adjust
330C Excavator Hydraulic System Main Pump (Flow) - Test - Constant Horsepower Flow Control
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers CID 0269 FMI 03 Sensor Supply too high
C7 and C9 Engines for Caterpillar Built Machines E198 Low Fuel Pressure
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders CID 0172 FMI 04 Intake Manifold Air Temp short to ground
2007/04/16 New Guidelines: When to Consult the Application Support Center (ASC) or the Dealer Solution Network (DSN) {1000}
330C With Drilling Front Machine System Specifications Fuel Tank
C7 and C9 Engines for Caterpillar Built Machines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0617 FMI 06 Air Inlet Heater Relay grounded/current above norm
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers Event Codes
305.5 Mini Hydraulic Excavator Plate Locations and Film Locations
330C Excavator UHD Supplement Specifications - Long Reach Configuration with a Retrofit Boom (One Position)
305.5 Mini Hydraulic Excavator Operator Controls
2005/06/13 An Improved Gerotor Motor Is Used {5082}
BR160, BR166, BR172, BR272 and BR378 Brush Cutters Safety Messages - Arrangement II