Fuel Tank
Show/hide table
 | |
| Illustration 1 | g01145217 |
(1) Torque for two bolts ... 6 ± 1 N·m (53 ± 9 lb in)
(2) The threads in the bosses must be clean before you install gauge.
(3) Apply 1U-8846 Gasket Sealant to the surface of the flange.
(4) Torque for five screws ... 1.4 ± 0.1 N·m (12 ± 1 lb in)
(5) Apply 5P-3413 Pipe Sealant to the threads.
Caterpillar Information System:
2007/04/16 New Guidelines: When to Consult the Application Support Center (ASC) or the Dealer Solution Network (DSN) {1000}
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders CID 0172 FMI 04 Intake Manifold Air Temp short to ground
C7 and C9 Engines for Caterpillar Built Machines E198 Low Fuel Pressure
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers CID 1603 FMI 09 Machine Control Module not communicating on link
C27 and C32 Generator Set Engines CID 1785 FMI 10 Intake Manifold Pressure Signal abnormal rate of change
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 04 Intake Manifold Pressure Sensor voltage low
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 03 Intake Manifold Pressure Sensor voltage high
330C Excavator Hydraulic System Specifications
330C Excavator Hydraulic System Gear Pump (Fan Motor) - Test
330C Excavator Hydraulic System Gear Pump (Pilot) - Test
330C Excavator Hydraulic System Pump Control (Negative Flow) - Adjust
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers CID 1603 FMI 12 Machine Control Module malfunction
C7 and C9 Engines for Caterpillar Built Machines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0617 FMI 06 Air Inlet Heater Relay grounded/current above norm
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers Event Codes
305.5 Mini Hydraulic Excavator Plate Locations and Film Locations
330C Excavator UHD Supplement Specifications - Long Reach Configuration with a Retrofit Boom (One Position)
305.5 Mini Hydraulic Excavator Operator Controls
2005/06/13 An Improved Gerotor Motor Is Used {5082}
BR160, BR166, BR172, BR272 and BR378 Brush Cutters Safety Messages - Arrangement II
C27 and C32 Generator Set Engines Inlet and Exhaust Valve Seat Inserts - Remove and Install
303E CR Mini Hydraulic Excavator Machine Systems Recoil Spring
305.5 Mini Hydraulic Excavator Gauges
M325C Material Handler Machine Systems Main Control Valve - Install