Boom Bearings and Seals - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0520 | Bearing and Seal Driver | 1 |
- Lower the temperature of the sleeve bearings. Use Tooling (A) to install the sleeve bearings in the pin bore at the foot of the boom. Install the sleeve bearings until Dimension (a) is
9.5 ± 0.8 mm (0.37 ± 0.03 inch) below the outside surface of the boom.Show/hide tableIllustration 2 g00869033 - Use Tooling (A) to install lip type seals (1) in the pin bore at the foot of the boom. Install the seals with the sealing lip toward the outside of the boom. Install the lip type seals until the lip type seals make contact with the bearings.
- Repeat Steps 1 and 2 in order to install the bearings and the lip type seals on the other side of the boom.
Show/hide table
Illustration 1 | g00599079 |
(X) Boom
(Y) Bearing |
End By:
- Install the boom. Refer to Disassembly and Assembly, "Boom - Install".
Caterpillar Information System:
303 CR Mini Hydraulic Excavator Work Tool Flow Control
321B LCR Excavator Fuses - Replace
321B LCR Excavator Fuel Tank Water and Sediment - Drain
321B LCR Excavator Fuel Tank Cap and Strainer - Clean
314C CR Excavator Hydraulic System Relief Valve (Pilot)
303 CR Mini Hydraulic Excavator Fuel System Water Separator - Drain
5090B Excavator Battery Disconnect Switch
314C CR Excavator Hydraulic System Hydraulic Filter (Pilot)
303 CR Mini Hydraulic Excavator Hydraulic System Main Hydraulic Pump
321B Excavator Hydraulic System Cylinder Drift - Check - Loaded Bucket
321B LCR Excavator Fuel System Water Separator - Drain
2002/05/27 A New Cover Assembly Is Available For Preventing the Accumulation of Debris in the Battery Compartment {1401}
365B, 365B Series II, 365BL, 385B and 5090B Excavators Machine Electronic Control System MID 039 - CID 1131 - FMI 13
385B and 5090B Excavators Excavator Systems Swing Drive - Disassemble
325C Excavator Machine Systems Fuel Tank - Install
314C CR Excavator Hydraulic System Accumulator (Pilot)
N3 Series Brushless Alternators Regulator - Test
303 CR Mini Hydraulic Excavator Hydraulic System Pump Control (Main Hydraulic)
GH52,GH55,GH60 Hydraulic Excavator Forestry Grapples Gerotor Motor Leakage - Test
365B, 365B Series II, 365BL, 385B and 5090B Excavators Machine Electronic Control System MID 039 - CID 1132 - FMI 13
5090B Excavator Boom, Stick and Bucket Operation
GSH9B, GSH15B and GSH20B Orange Peel Grapples Shell Assembly - Install
321B LCR Excavator Hydraulic System Oil - Change
365B, 365B Series II, 365BL, 385B and 5090B Excavators Machine Electronic Control System MID 039 - CID 0376 - FMI 05