Engine Oil Level Switch - Remove and Install
Removal Procedure
Start By:
- Remove the engine oil filler and oil level gauge. Refer to Disassembly and Assembly, "Engine Oil Filler and Oil Level Gauge - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect nut (1) .
Show/hide table
Illustration 1 | g00649178 |
- Remove bolts (2) and the washers.
- Disconnect the harness assembly from contactor switch (3). Remove contactor switch (3) .
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install contactor switch (3). Connect the harness assembly to contactor switch (3) .
Show/hide table
Illustration 2 | g00649178 |
- Install bolts (2) and the washers.
- Connect nut (1) .
End By: Install the engine oil filler and oil level gauge. Refer to Disassembly and Assembly, "Engine Oil Filler and Oil Level Gauge - Remove and Install".
Caterpillar Information System:
Customer Communication Module (CCM) for Diesel Engines Data Link Guidelines
C9 Engine For Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C9 Engines for Caterpillar Built Machines Cylinder Liner - Install
C-9 Engines for Caterpillar Built Machines Cylinder Liner Projection
Customer Communication Module (CCM) for Diesel Engines General Wiring Diagram
3612 and 3616 Engines Electric Starting Motor - Remove and Install
C9 On-highway Engines Engine Operation
C9 On-highway Engines Diagnostic Lamp
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AL Fault Code - Troubleshoot
C9 On-highway Engines Monitoring System
Installation Of Double Wall Fuel Lines For 3412C High Performance Marine Engines{1252} Installation Of Double Wall Fuel Lines For 3412C High Performance Marine Engines{1252}
Uninterruptible Power Supply (UPS) 250 Symbols
3406E and 3456 Engines for Caterpillar Built Machines Troubleshooting
C-9 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
3054B Industrial Engine Gear Group (Front) - Remove
3054B Industrial Engine Gear Group (Front) - Install
3126B Engine for Caterpillar Built Machines Engine Will Not Crank
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0277 - FMI 08 Timing Calibration signal abnormal
30SI Series and 34SI Series Alternator T1 Alternator Output - Test
30SI Series and 34SI Series Alternator T2 Electrical System Current - Test
3406E and 3456 Generator Set Engines Fuel Quality - Test
30SI Series and 34SI Series Alternator T3 Charging System - Test
30SI Series and 34SI Series Alternator T4 Alternator Drive System - Check
30SI Series and 34SI Series Alternator T5 Alternator Current - Test