C9 Engines for Caterpillar Built Machines Caterpillar


Cylinder Liner - Install

Usage:

TK711 101

安装步骤

表 1
需要的工具 
工具  零件号  零件说明  数量 
2P-8260  缸套安装工具 
5P-3975  橡胶润滑剂 


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。


  1. 检查缸套凸出量。 请参阅测试和调整, "缸套凸出量 - 检查"。


    图 1g01139009

  2. 在新油封 (2) 上涂抹工具 (C)。 在缸套 (1) 的机加工槽中安装新油封 (2)。

  3. 用清洁的发动机机油润滑缸套 (1) 下部。 确保相应曲轴行程处于底部中央。 使用工具 (B),安装缸套 (1)。

结束:

  1. 安装活塞和连杆。 请参阅解体和组装, "活塞和连杆 - 安装"。

Caterpillar Information System:

C-9 Engines for Caterpillar Built Machines Cylinder Liner Projection
Customer Communication Module (CCM) for Diesel Engines General Wiring Diagram
3612 and 3616 Engines Electric Starting Motor - Remove and Install
C9 On-highway Engines Engine Operation
C9 On-highway Engines Diagnostic Lamp
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AL Fault Code - Troubleshoot
C9 On-highway Engines Monitoring System
Installation Of Double Wall Fuel Lines For 3412C High Performance Marine Engines{1252} Installation Of Double Wall Fuel Lines For 3412C High Performance Marine Engines{1252}
Uninterruptible Power Supply (UPS) 250 Symbols
Uninterruptible Power Supply (UPS) 250 Electrical System
Uninterruptible Power Supply (UPS) 250 General Hazard Information
Uninterruptible Power Supply (UPS) 250 Fire Prevention and Explosion Prevention
C9 Engine For Caterpillar Built Machines Pistons and Connecting Rods - Assemble
Customer Communication Module (CCM) for Diesel Engines Data Link Guidelines
3618 Engine Engine Oil Level Switch - Remove and Install
3406E and 3456 Engines for Caterpillar Built Machines Troubleshooting
C-9 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
3054B Industrial Engine Gear Group (Front) - Remove
3054B Industrial Engine Gear Group (Front) - Install
3126B Engine for Caterpillar Built Machines Engine Will Not Crank
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0277 - FMI 08 Timing Calibration signal abnormal
30SI Series and 34SI Series Alternator T1 Alternator Output - Test
30SI Series and 34SI Series Alternator T2 Electrical System Current - Test
3406E and 3456 Generator Set Engines Fuel Quality - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.