Alternate Exit
Show/hide table
| |
| Illustration 1 | g00845565 |
|
(1) O-ring seal
(2) Ring | |
The rear window serves as an alternate exit.
To remove the rear window, pull ring (2) and push out the glass.
Completely remove O-ring seal (1) from the seal that supports the glazing support seal. This will provide enough clearance so that the seal can hinge and the glazing can pass outward.
Caterpillar Information System:
C15 Petroleum Generator Set Engines Electronic Unit Injector - Adjust
M312, M315, M318 and M320 Excavators Hydraulic System Relief Valve (Signal Limiter) - No Heavy Lift
3500B Engines General Information (Electronic Control System)
3500B Engines for 5130B and 5230B Excavators Ground Level Shutdown Switch
305 CR Mini Hydraulic Excavator Cab Door - If Equipped
G3406 Engine Grounding Practices
5230B Excavator Hydraulic System Solenoid Valves (Pilot Manifold)
305 CR Mini Hydraulic Excavator Window (Front) - If Equipped
305 CR Mini Hydraulic Excavator Tool Box
3500B Engines for 5130B and 5230B Excavators Ether Injection System
305 CR Mini Hydraulic Excavator Seat
5130B Excavator Automatic Lubrication System Grease - Add
2001/07/30 A New Return Spring for the Governor Motor Improves Service Life {1408}
3064 and 3066 Engines for Caterpillar Built Machines Camshaft - Remove
3500B Engines Camshaft
3500B Engines Crankshaft
305 CR Mini Hydraulic Excavator Engine Speed Control
3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Remove
5130B Excavator Swing Drive Oil - Change
305 CR Mini Hydraulic Excavator Low Idle Control
5130B Excavator Swing Bearing Bolts - Check
3064 and 3066 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install
3500B Engines for 5130B and 5230B Excavators Injector Solenoids
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator - Disassemble - M1 Series Alternator (35 Amp)