Flywheel Housing Runout
Usage:
8S2328 DIAL INDICATOR GROUP INSTALLED
Face Runout (axial eccentricity) of the Flywheel Housing:
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at .000 in. (0.0 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken all four points must not be more than .012 in. (0.30 mm), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
5.4" BORE, 60 V12 VEHICULAR ENGINE Flywheel Runout
5.4" BORE, 60 V12 VEHICULAR ENGINE Flywheel Housing
5.4" BORE, 60 V12 VEHICULAR ENGINE Flywheel
5.4" BORE, 60 V12 VEHICULAR ENGINE Engine Support For 992, 776, 777
5.4" BORE, 60 V12 VEHICULAR ENGINE Vibration Damper (2N7221 and 4N4416)
5.4" BORE, 60 V12 VEHICULAR ENGINE Vibration Damper (5S3419 and 2S712)
5.4" BORE, 60 V12 VEHICULAR ENGINE Main Bearings
5.4" BORE, 60 V12 VEHICULAR ENGINE Connecting Rod Bearings
5.4" BORE, 60 V12 VEHICULAR ENGINE Bearing Surface (Journal) For Main Bearings
5.4" BORE, 60 V12 VEHICULAR ENGINE Bearing Surface (Journal) For Connecting Rods
5.4" BORE, 60 V12 VEHICULAR ENGINE Crankshaft
5.4" BORE, 60 V12 VEHICULAR ENGINE Connecting Rods
5.4" BORE, 60 V12 VEHICULAR ENGINE Flywheel Housing Bore
5.4" BORE, 60 V12 VEHICULAR ENGINE Alternators
5.4" BORE, 60 V12 VEHICULAR ENGINE Starting Motors - 5L3648, 4N3349
5.4" BORE, 60 V12 VEHICULAR ENGINE Starting Motors - 7L8797, 4N8118
5.4" BORE, 60 V12 VEHICULAR ENGINE Starter Solenoids
5.4" BORE, 60 V12 VEHICULAR ENGINE Starter Magnetic Switches
5.4" BORE, 60 V12 VEHICULAR ENGINE Shut-Off Solenoids
5.4" BORE, 60 V12 VEHICULAR ENGINE Voltmeter
5.4" BORE, 60 V12 VEHICULAR ENGINE V-Belt Tension Chart
Installation Procedure For The 138-7020 Harness Assembly{1408} Installation Procedure For The 138-7020 Harness Assembly{1408}
Calibrating The 133-8985 Governor And Fuel Injection Pump Group Heavy Sleeve Metering Fuel System (HSMFS){650, 1250} Calibrating The 133-8985 Governor And Fuel Injection Pump Group Heavy Sleeve Metering Fuel System (HSMFS){650, 1250}
Generator Set Start-up Checklist{1021, 1404, 7002} Generator Set Start-up Checklist{1021, 1404, 7002}