Disassembly Procedure for the Track Carrier Roller on CIPI Undercarriage Arrangements which are Based on 330 and 330B Track Type Excavators
Start By:
- Remove the track carrier rollers. Refer to Disassembly and Assembly, "Track Carrier Roller - Remove" in this manual.
Reference: Refer to Undercarriage Reconditioning Bulletin, SEBF8568, "Hydraulic Excavator Roller Disassemble and Assembly Procedures" for the disassembly and assembly procedures for the track carrier roller.
- Thoroughly clean the outside of the track carrier roller prior to disassembly.
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Show/hide table
|
|
|
Illustration 1 | g00489477 |
- Remove plug (2). Drain the oil from the carrier roller into a suitable container for disposal. The capacity of the track carrier roller is 180 ± 10 mL (6.12 ± .34 oz).
- Remove three socket head bolts (1) and cover (3) from the track carrier roller.
Show/hide table
|
|
|
Illustration 2 | g00489481 |
- Remove O-ring seal (4) from cover (3) .
Show/hide table
|
|
|
Illustration 3 | g00489486 |
- Remove washer (5) .
Show/hide table
|
|
|
Illustration 4 | g00489493 |
- Remove two socket head bolts (6) and retainer (7) from the end of the shaft assembly.
Show/hide table
|
|
|
Illustration 5 | g00489495 |
- Carefully remove shaft assembly (8) from the track carrier roller.
Show/hide table
|
|
|
Illustration 6 | g00489497 |
- Remove Duo-Cone seal (9) from the track carrier roller.
Show/hide table
|
|
|
Illustration 7 | g00489499 |
- Remove Duo-Cone seal (10) from shaft assembly (8) .
Show/hide table
|
|
|
Illustration 8 | g00489522 |
- Measure distance "X" on the shaft assembly. Record this dimension for assembly purposes. Use a press to push shaft (8) out of collar (11). Remove the O-ring seal from the inside of the collar.
Show/hide table
|
|
|
Illustration 9 | g00489523 |
Show/hide table
|
|
|
Illustration 10 | g00367312 |
- Remove bearings (12) and (13) from the track carrier roller.