Maintenance Interval Schedule
Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.
Pneumatic Drum Clutch Air Control Components - Inspect
Torsional Coupling - Inspect
Gearbox Oil and Oil Filter - Change
Gearbox Hub Bolts and Flange Bolts - Check
Heat Exchanger - Clean
Pneumatic Drum Clutch - Inspect
Torsional Coupling - Disassemble/Clean/Inspect
Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.
Note: For information on engine maintenance, see the Operation and Maintenance Manual for the engine. For information on maintaining the compressor, see the literature that is provided by the OEM of the compressor.
Daily
Walk-Around InspectionEvery 500 Service Hours
Torsional Coupling - CheckEvery 1000 Service Hours
Pneumatic Drum Clutch - LubricatePneumatic Drum Clutch Air Control Components - Inspect
Torsional Coupling - Inspect
Every 2500 Service Hours or 6 Months
Gearbox Oil Analysis - ObtainGearbox Oil and Oil Filter - Change
Every Year
Flexible Coupling - InspectGearbox Hub Bolts and Flange Bolts - Check
Heat Exchanger - Clean
Pneumatic Drum Clutch - Inspect
Every 18 000 Service Hours
Gearbox Gear Teeth - InspectTorsional Coupling - Disassemble/Clean/Inspect
Every 40 000 Service Hours
Torsional Coupling Spring Packs - ReplaceCaterpillar Information System:
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Install
3606 and 3608 Engines Lubrication System Operation
3406E Generator Set Engines Instrument Panel - Inspect
G3606 and G3608 Engines Crankcase Explosion Relief Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
G3606 and G3608 Engines Engine Oil Filler - Remove and Install
PM820, PM822, and PM825 Cold Planer Operation
G3408 and G3412 Engines Gas Engine Ignition
3412E and C30 Marine Engines Cooling System
3412E and C30 Marine Engines Air Starting System
G3606 and G3608 Engines Turbocharger - Disassemble
3606 and 3608 Engines Air Inlet and Exhaust System Operation
3406C (PEEC III) Truck Engines Troubleshooting
3600 Distillate Fuel Engines Trend Data - Record
365B and 365B Series II Excavators Hydraulic System Graphic Color Codes
3304B and 3306B Engines for Caterpillar Built Machines Cylinder Liner - Install
G3606 and G3608 Engines Water Pump - Remove
797 Off-Highway Truck Steering System Check Valve (Steering)
G3606 and G3608 Engines Water Pump - Install
G3606 and G3608 Engines Water Pump - Disassemble
3412E and C30 Marine Engines Air Starting System
G3606 and G3608 Engines Water Pump - Assemble
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Disassemble
3406C (PEEC III) Truck Engines Engine Vibration Troubleshooting