3306B Industrial Engine Caterpillar


Engine Oil Pressure

Usage:

3306B 1BM
遵循本程序的所有步骤以获得可用的机油压力读数。

  1. 确保发动机使用SAE 10W-30机油,并加注到正确油位。 如果使用了粘度不对的机油,发动机机油压力图将会不准确。

  1. 拆下机油压力开关。 把 1U-5470 发动机压力测试组件 连接到主油道上。 进行此连接时,使用机油压力开关的孔口。

  1. 运转发动机。 让发动机机油温度上升到99°C (210°F)。

    注: 发动机机油温度每升高3°C (5°F),发动机机油压力就降低7 kPa (1 psi)。

    注: 确保发动机机油温度不要超过115°C (239°F)。

  1. 使在额定转速下运转的发动机的机油温度保持一致,读取压力表读数。

  1. 使用发动机转速和机油压力在发动机机油压力图上定位交叉点。



    图 1g00292588

  1. 结果应在图中可接受的范围内。 如果结果是不可接受的,查找问题的原因并解决问题。 长期在机油压力超出可接受范围的情况下运转可能导致发动机发生故障或降低发动机使用寿命。

    注: 保存定期读取发动机机油压力读数的记录。 此记录能够指示可能存在或发生的发动机问题或损坏。 应检查机油压力突然升高或降低70 kPa (10 psi)的情况,即使此时机油压力仍在发动机机油压力图的可接受范围。

Caterpillar Information System:

3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
Gas Engine Driven Chiller Driveline Pneumatic Drum Clutch - Inspect
Gas Engine Driven Chiller Driveline Heat Exchanger - Clean
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
3306B Industrial Engine Flywheel Housing
Gas Engine Driven Chiller Driveline Gearbox Oil and Oil Filter - Change
Gas Engine Driven Chiller Driveline Gearbox Oil Analysis - Obtain
Gas Engine Driven Chiller Driveline Gearbox Hub Bolts and Flange Bolts - Check
3306C Engines for Caterpillar Built Machines Flywheel Housing
Gas Engine Driven Chiller Driveline Gearbox Gear Teeth - Inspect
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Filter Base - Install
3306B Industrial Engine Flywheel
3304B and 3306B Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C-12 Truck Engine Cooling System
P16, P20, P25, P28, P40 and P60 Pulverizers Rotator Motor
3306C Engines for Caterpillar Built Machines Fuel Filter Base
3306B Industrial Engine Overhaul Considerations
3406E On-Highway Engine Valve Mechanism Cover - Remove and Install
3306B Industrial Engine Engine Oil Pan
3306B Industrial Engine Camshaft Bearings - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
3406C (PEEC III) Truck Engine Compression Brake
3306B Industrial Engine Engine Support (Front)
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Pump - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.