2570D and 2670D Wheel Feller Buncher Engine Supplement Caterpillar


Water Pump - Remove and Install

Usage:

2570D D25

Removal Procedure

------ WARNING! ------

Personal injury can result from hot coolant, steam and alkali.

At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.

Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.

Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.

Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.


  1. Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.


    Illustration 1g06126369

  2. Remove bolts (1) and open door assembly (2).


    Illustration 2g06126530

  3. Disconnect hose assembly (3).

  4. Loosen clamp (6) and disconnect hose (7).

  5. Remove bolts (5), water pump (4), and the gasket.

Installation Procedure

  1. Install water pump (4) in the reverse order of removal.


      Illustration 3g01985813

    1. Tighten the bolts in the sequence shown to a torque of 22 N·m (195 lb in).

Caterpillar Information System:

PM820, PM822, and PM825 Cold Planer Machine Systems Rotor Drive Clutch - Assemble
Procedure to Improve the Air Dryer System on Certain 785D Off-Highway Trucks {0679, 1451, 4285, 7050, 7051} Procedure to Improve the Air Dryer System on Certain 785D Off-Highway Trucks {0679, 1451, 4285, 7050, 7051}
PL61 Pipelayer Power Train Front Idler and Yoke - Install
PL61 Pipelayer Power Train Front Idler and Yoke - Remove
PM820, PM822, and PM825 Cold Planer Machine Systems Rotor Drive Clutch - Disassemble
PM820, PM822, and PM825 Cold Planer Machine Systems Wear Plate (Rotor Chamber) - Remove and Install
Service Maintenance Interval Reset Option Is Now Available on Certain Compact Track Loaders, Multi-Terrain Loaders, and Skid Steer Loaders {7000} Service Maintenance Interval Reset Option Is Now Available on Certain Compact Track Loaders, Multi-Terrain Loaders, and Skid Steer Loaders {7000}
994K Wheel Loader Machine Systems Brake Control Valve (Service) - Remove and Install
Procedure to Improve the Air Dryer System on Certain 789D Off-Highway Trucks {4272, 4285} Procedure to Improve the Air Dryer System on Certain 789D Off-Highway Trucks {4272, 4285}
994K Wheel Loader Machine Systems Brake Accumulator - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Gear Motor - Remove and Install - Ventilation
730C2 and 725C2 Articulated Truck Power Train Transfer Case - Disassemble - Center Axle
R1700 Load Haul Dump Power Train, Steering, Braking, Hydraulic, and Machine Systems General Information (Power Train System)
R1700 Load Haul Dump Power Train, Steering, Braking, Hydraulic, and Machine Systems Location of Components (Power Train System)
A New Clean Fuel Module Pump is Available for Certain Large Off-Highway Trucks {1255, 1256} A New Clean Fuel Module Pump is Available for Certain Large Off-Highway Trucks {1255, 1256}
730C2 and 725C2 Articulated Truck Power Train Differential Pinion - Disassemble - Front and Rear
730C2 and 725C2 Articulated Truck Power Train Differential Pinion - Assemble - Front and Rear
AP300F Asphalt Paver Diesel Particulate Filter Regeneration
C7.1 Engines and Generator Sets ARD Fuel Pressure Is Low
2570D and 2670D Wheel Feller Buncher Engine Supplement Precleaner - Remove and Install
2570D and 2670D Wheel Feller Buncher Engine Supplement Air Cleaner - Remove and Install
A New Carrier Assembly With a Sleeve Bearing, Rotating Clutch Housing and Seals are Now Used in Certain 700 C-Series Articulated Trucks {3030, 3160} A New Carrier Assembly With a Sleeve Bearing, Rotating Clutch Housing and Seals are Now Used in Certain 700 C-Series Articulated Trucks {3030, 3160}
A Procedure to Repair the Corner of the Truck Body Canopy on Certain 770G and 772G Off-Highway Trucks is Now Available {0679, 7250, 7258} A Procedure to Repair the Corner of the Truck Body Canopy on Certain 770G and 772G Off-Highway Trucks is Now Available {0679, 7250, 7258}
C7.1 Engines and Generator Sets ARD Is Disabled
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.