Air Inlet Heater
Show/hide table
Illustration 1 | g00292365 |
Section view of the air inlet heater |
(1) Air inlet heater
(2) Tighten the nuts to the following torque. ...
Note: During assembly of the air inlet heater to the inlet manifold and the air inlet elbow, clean the air inlet heater's joint faces with solvent. Apply 4C-9500 Quick Cure Primer to the joint faces. Allow the primer to air dry for a minimum of three to five minutes. Apply 8C-8422 Sealant to the joint face and spread the gasket maker uniformly. The heater must be assembled and tightened within ten minutes.
Caterpillar Information System:
G3612 and G3616 Engines Abbreviations and Symbols
C-9 Industrial Engine Alternator and Regulator
3126 Truck Engine Air Compressor - Bendix Tu-Flo Air Compressors
3406E Truck Engines Electrical System
3116 Truck Engines Engine Oil Cooler Bypass Valve
3126B Truck Engine Air Inlet Elbow
G3606 and G3608 Engines Engine Design
3208 Marine Engine Engine Crankcase Breather - Clean
3126B Engine for Caterpillar Built Machines Cylinder Head Valves
3126B Engine for Caterpillar Built Machines Valve Rocker Arms, Lifters, and Bridges
3126B and 3126E Truck Engines Valve Mechanism Cover
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve
3126B and 3126E Truck Engines Electronic Control Wiring Group
G3612 and G3616 Engines Fuel System
3208 Marine Engine Engine Shutoffs and Engine Alarms
3126B Marine Engine Cylinder Head
3406C (PEEC III) Truck Engines Brakesaver
G3612 and G3616 Engines Lubrication System
3126B Engine for Caterpillar Built Machines Engine Oil Pump
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Engine Oil Pressure
3126B and 3126E Truck Engines Water Pump
G3612 and G3616 Engines Basic Block
3054 Engine Alternator and Regulator
3054 Engine Fuel Injection Pump