Manual Valve Group (Cylinder Pressure)
Show/hide table
Illustration 1 | g00288330 |
Note: Apply 4C-5598 High Temperature Anti-Seize to the threads.
(1) Tighten the cap to the following torque. ... 17 ± 3 N·m (13 ± 2 lb ft)
(2) Tighten the valve to the following torque. ... 24 ± 3 N·m (18 ± 2 lb ft)
(3) Tighten the manual valve group to the following torque. ... 70 ± 30 N·m (52 ± 22 lb ft)
Note: View the manual valve group from the side of the engine. Ensure that the manual valve group is between the position of 8 o'clock and the position of 1 o'clock. This orientation will allow access to the manual control valve without interference from the fuel lines.
Caterpillar Information System:
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
Torque Specifications Miscellaneous Fittings
G3612 and G3616 Engines Cylinder Liner
Torque Specifications Tapered Pipe Thread Fittings
Torque Specifications Air Conditioning Fittings
Torque Specifications Flare Fittings
3406E Truck Engine Turbocharger
3612 and 3616 Engines Air Starting Motor
3406C (PEEC III) Truck Engine Cylinder Liner
3612 and 3616 Engines Gear Group (Front)
3406C Engines for Caterpillar Built Machines Main Bearing Journal
3406C Engines for Caterpillar Built Machines Connecting Rod Bearing Journal
G3612 and G3616 Engines Prelube Pump
3406E Truck Engine Housing (Front)
3612 and 3616 Engines Housing (Front)
3608 Engine Housing (Rear)
3612 and 3616 Engines Crankshaft
3406E Truck Engine Exhaust Manifold Shield
3406E Truck Engine Accessory Drive (Air Compressor)
3408E and 3412E Engines for Caterpillar Built Machines Crankcase Breather
3406E Truck Engine Water Pump
3618 Engine Engine Oil Pump
3618 Engine Camshaft Bearings
3406C (PEEC III) Truck Engine Flywheel Housing