Cylinder Liner
Show/hide table
Illustration 1 | g00288159 |
The following steps are for installing the cylinder liner into the cylinder block.
- Apply liquid soap on the cylinder block liner bore surfaces. Apply liquid soap on the rubber seals on the lower part of the cylinder liner.
- Put the filler band completely in clean engine oil for a moment.
- Install the filler band (3) in the groove under the liner flange without delay.
- Install the liner in the bore immediately, before the filler band expands.
(1) Bore in new liner ... 137.19 ± 0.03 mm (5.401 ± 0.001 inch)
(2) Thickness of flange on liner ... 8.890 ± 0.020 mm (0.3500 ± 0.0008 inch)
The minimum thickness of the part that can be used again is the following value. ... 8.870 mm (0.3492 inch)
(3) Filler band
Note: Refer to Guideline For Reusable Parts, SEBF8049 and Pistons And Cylinder Liners, SEBF8068.
Caterpillar Information System:
3612 and 3616 Engines Gear Group (Front)
3406C Engines for Caterpillar Built Machines Main Bearing Journal
3406C Engines for Caterpillar Built Machines Connecting Rod Bearing Journal
3406E Truck Engine Piston and Rings
3406E Truck Engine Connecting Rod
Torque Specifications Installation of Fittings
Torque Specifications O-Ring Face Seal Fittings
3618 Engine Cylinder Liner
Torque Specifications Straight Thread O-Ring Fittings
3406E Truck Engine Engine Oil Filler
3406E and 3456 Industrial Engines Rocker Shaft
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3612 and 3616 Engines Air Starting Motor
3406E Truck Engine Turbocharger
Torque Specifications Flare Fittings
Torque Specifications Air Conditioning Fittings
Torque Specifications Tapered Pipe Thread Fittings
G3612 and G3616 Engines Cylinder Liner
Torque Specifications Miscellaneous Fittings
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
3618 Engine Manual Valve Group (Cylinder Pressure)
G3612 and G3616 Engines Prelube Pump
3406E Truck Engine Housing (Front)
3612 and 3616 Engines Housing (Front)