Cylinder Liner
Show/hide table
Illustration 1 | g00288319 |
(1) Groove for the Combustion gasket
- Depth of groove ... 3.50 ± 0.05 mm (.138 ± .002 inch)
- The dimension must not vary more than the following value. ... 0.020 mm (.0008 inch)
(2) Bore in new liner ... 300.025 ± 0.025 mm (11.8120 ± .0010 inch)
Note: Measure the bore at four locations along the depth of the liner. Each location should be 90 degrees from each other.
(3) Flange
- Thickness of flange ... 33.00 ± 0.03 mm (1.299 ± .001 inch)
- The dimension must not vary more than the following value. ... 0.013 mm (.0005 inch)
Caterpillar Information System:
Torque Specifications Tapered Pipe Thread Fittings
Torque Specifications Air Conditioning Fittings
Torque Specifications Flare Fittings
3406E Truck Engine Turbocharger
3612 and 3616 Engines Air Starting Motor
3406C (PEEC III) Truck Engine Cylinder Liner
3612 and 3616 Engines Gear Group (Front)
3406C Engines for Caterpillar Built Machines Main Bearing Journal
3406C Engines for Caterpillar Built Machines Connecting Rod Bearing Journal
3406E Truck Engine Piston and Rings
3406E Truck Engine Connecting Rod
Torque Specifications Installation of Fittings
Torque Specifications Miscellaneous Fittings
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
3618 Engine Manual Valve Group (Cylinder Pressure)
G3612 and G3616 Engines Prelube Pump
3406E Truck Engine Housing (Front)
3612 and 3616 Engines Housing (Front)
3608 Engine Housing (Rear)
3612 and 3616 Engines Crankshaft
3406E Truck Engine Exhaust Manifold Shield
3406E Truck Engine Accessory Drive (Air Compressor)
3408E and 3412E Engines for Caterpillar Built Machines Crankcase Breather
3406E Truck Engine Water Pump