Engine Enclosure (Hood)
Show/hide table
Illustration 1 | g03738803 |
Show/hide table
Specification for 422-4379 Engine Enclosure Gp     | |||
---|---|---|---|
Item     | Qty     | Part     | Specification Description     |
1     | 1     | 226-0294 Lock As     | Tighten the cam screw to 3.4 ± 0.5 N·m (30.1 ± 4.4 lb in). Tighten the jam nut to 8.5 ± 2.0 N·m (75.2 ± 17.7 lb in).     |
2     | 4     | 8T-5001 Bolt     | Torque to 15 ± 3 N·m (133 ± 27 lb in).     |
3     | 4     | 280-3991 Ball Stud     | Before assembly, apply blue Loctite 243 to the threads. Torque to 21 ± 2 N·m (186 ± 18 lb in).     |
Caterpillar Information System:
R1700G Load Haul Dump Machine Systems Pilot Valve (STIC Steering) - Install
2014/10/27 Improved Solenoid Valve Group Is Now Used On Certain Load Haul Dumps and Wheel Loaders {3073, 3139, 5479}
PL83 and PL87 Pipelayers Mounting and Dismounting
735C and 745C Articulated Trucks Machine Systems Power Train Hydraulic System
RM500B Reclaimer Mixer Machine Systems Relief Valve (Charge, Emulsion Spray) - Test and Adjust
AP500F Asphalt Paver Stopping the Machine
RM500B Reclaimer Mixer Machine Systems Emulsion Pump - Test
MH3022, MH3024 and MH3026 Material Handlers Hydraulic System Electronic Control (Machine System)
MH3022, MH3024 and MH3026 Material Handlers Hydraulic System Location of Components (Machine System)
MH3022, MH3024 and MH3026 Material Handlers Hydraulic System General Information (Machine System)
794 AC Off-Highway Truck Engine Supplement Engine Oil Cooler - Remove and Install
M318F, M320F and M322F Wheeled Excavators Hydraulic System Case Drain (Travel Motor) - Test
RM500B Reclaimer Mixer Machine Systems Hood - LH
RM500B Reclaimer Mixer Machine Systems Hydraulic Tank
RM500B Reclaimer Mixer Machine Systems Rotor Brake
RM500B Reclaimer Mixer Machine Systems Rotor Drive Shaft
RM500B Reclaimer Mixer Machine Systems Hood - RH
RM500B Reclaimer Mixer Machine Systems Hydraulic Cylinder (Hood Tilt)
2014/10/27 New Converter Impeller and Impeller Hub are Now Used on Certain 24M Motor Graders {3101}
2014/11/13 New Transmission Software to Prevent Excessive Ejector Blade Drift When the Machine is Stationary on an Incline is Available for Certain Articulated Trucks {7620}
2014/11/10 A New Installation Procedure is Used for the Clean Emissions Module (CEM) Fan Components on Certain Articulated Trucks {1050}
2014/10/27 An Improved Installation Procedure for the Injector Top O-Ring Seal on C27 and C32 Machine Engines {1251, 1254, 1290, 1713}
2014/10/27 New Guidelines for Valve Cover Base Threaded Insert on C27 and C32 Engines {1107, 1120}
MH3022, MH3024 and MH3026 Material Handlers Sensor Supply - Test