Installation Procedure for Mounting the Rear Radar On Certain Cat® Products{7347, 7605} Caterpillar

Installation Procedure for Mounting the Rear Radar On Certain Cat® Products{7347, 7605}

Usage:

825K 233

Soil Compactor:: 825K (S/N: SEE1-UP; 2331-UP)
Wheel Dozer:: 824K (S/N: RWB1-UP; 2341-UP)

Introduction

This Special Instruction provides the installation procedure for mounting the rear radar on certain Cat^® Products.

Important Safety Information

Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.

Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.

A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.

Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.

Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.

Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used.

Show/hide table

Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.

Show/hide table

Accidental engine starting can cause injury or death to personnel working on the equipment.
To avoid accidental engine starting, turn the battery disconnect switch to the OFF position. Remove the key for the battery disconnect switch. Use a secure padlock in order to lock the battery compartment access door.

Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.

Show/hide table

Personal injury or death can result from fumes, gases and ultraviolet rays from the weld arc.
Welding can cause fumes, burn skin and produce ultraviolet rays.
Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing area. Wear eye, ear and body protection before working.
Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can cause death.
Read and understand the manufacturer's instructions and your employer's safety practices. Do not touch live electrical parts.
See "American National Standard Z49.1, Safety in Welding and Cutting" published by the American Welding Society.
American Welding Society
2501 N.W. 7th Street
Miami, Florida 33125

See "OSHA Safety and Health Standards, 29 CFR 1910", available from U.S. Department of Labor.
U.S. Department of Labor
Washington, D.C. 20210

Show/hide table

NOTICE

Before carrying out arc welding on the machine or on any equipment attached to the machine, disconnect all power and ground leads from the batteries in order to avoid possible damage to electronic components.