Control Valve (Auxiliary) - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 283-1493 | Tube Assy. | 1 |
283-1500 | Locking Pin | 1 | |
283-1480 | Base | 1 | |
B | 439-3940 | Bracket As | 2 |
Start By:
- Connect the steering frame lock.
- Raise lift arms (1) and position Tooling (A) in order to support lift arms (1).
- Release the hydraulic system pressure.
- Retain the hydraulic tank oil.
- Move the disconnect switch to the OFF position.
Show/hide table
Illustration 2 g03644866 - Remove plates (2) and panel (3).
Show/hide table
Illustration 3 g03644874 Show/hide tableIllustration 4 g03644893 - Disconnect tube assemblies (4). Disconnect harness assemblies (5) from both sides of the auxiliary valve. Remove ladder clip (6). Remove bolts (7). Set tube assemblies (4) out of the way.
Show/hide table
Illustration 5 g03644953 - Disconnect hose assembly (8).
Show/hide table
Illustration 6 g03644962 - Disconnect hose assemblies (9).
Show/hide table
Illustration 7 g03644974 - Disconnect hose assembly (10).
Show/hide table
Illustration 8 g03645106 - Attach Tooling (B) and a suitable lifting device to auxiliary control valve (11). The weight of auxiliary control valve (11) is approximately
68 kg (150 lb) . - Remove the three bolts (not shown) underneath auxiliary control valve (11). Remove auxiliary control valve (11).
Show/hide table
Illustration 1 | g03329520 |
- Install auxiliary control valve (11) in the reverse order of removal.
Note: If auxiliary control valve (11) was disassembled and then assembled, the following steps must be performed after the installation procedure.
- Refer to Testing and Adjusting, "Relief Valve Line - Test and Adjust" for the relief and check valves.
- Refer to Testing and Adjusting, "Pressure Limiter (Auxiliary Valve) Check and Adjust" for the pressure limiter valve.
Caterpillar Information System:
Inaccurate Hour Meter Reading on Electronic Monitoring System III (EMS III) Used on Certain Off-Highway Trucks{7478, 7490} Inaccurate Hour Meter Reading on Electronic Monitoring System III (EMS III) Used on Certain Off-Highway Trucks{7478, 7490}
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Transmission Oil Pump
980M and 982M Wheel Loaders Declaration of Conformity
980L Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Drive Shaft
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Ride Control Accumulator
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Relief Valve (Brake Accumulator)
Procedure to Install 435-3715 Waste Handling Option Ar on Certain Wheel Loaders {0679, 7000, 7150, 7960} Procedure to Install 435-3715 Waste Handling Option Ar on Certain Wheel Loaders {0679, 7000, 7150, 7960}
415F2 Backhoe Loader Joystick Control - Loader
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Pressure Sensor
2014/03/06 New Hose Clamps are Now Used on the Cab Riser for MH3049 and MH3059 Material Handlers {5057}
980L Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Front Guard
New Tube Assembly for the Low-Pressure Fuel System on Certain C6.6 Machine Engines{1274} New Tube Assembly for the Low-Pressure Fuel System on Certain C6.6 Machine Engines{1274}
MH3037 Material Handler Hydraulic System Swing Pump Air - Purge
415F2 Backhoe Loader Engine Oil and Filter - Change
SE60 VT XW and SE60 V XW Asphalt Screed Machine Systems Screed Plates - Check/Replace and Adjust - Main Screed
Procedure to Relocate the Circuit Breaker Group on the 797F Off-Highway Truck{0679, 1408, 1420, 1808, 5500, 5501, 7051} Procedure to Relocate the Circuit Breaker Group on the 797F Off-Highway Truck{0679, 1408, 1420, 1808, 5500, 5501, 7051}
415F2 Backhoe Loader Engine Oil Sample - Obtain
415F2 Backhoe Loader Engine Oil Level - Check
415F2 Backhoe Loader Belts - Inspect/Adjust/Replace
2014/08/18 New Engine Harness Routing {1408}
980M and 982M Medium Wheel Loaders Sensor Signal (Analog, Passive) - Test
980M and 982M Medium Wheel Loaders Sensor Signal (PWM) - Test
2014/03/27 A Procedure to Relocate the Circuit Breaker Group on the 797F Off-Highway Truck is Available {0679, 1408, 1420, 1808, 5500, 5501, 7051}
415F2 Backhoe Loader Fuel System Secondary Filter - Replace