1993/10/18 Caterpillar

24V Fog Lamp Now Available {1400}

Usage:

All 24V Machines

A sealed beam fog lamp is now available for 24V machines. The fog lamp size is a PAR46, which is 146 mm (5.75 in) in diameter. The 110-3242 Lamp Group consists of a 110-3239 Lamp and a 110-3238 Body Assembly and is adaptable to all 24V machines where there is space to mount the lamps. The lamp and body are serviced separately while the 110-3242 Lamp Group is not. Also, a 8T-4122 Mounting Washer and 6B-6683 Mounting Nut must be ordered separately. The 110-3238 Body Assembly has a 5/8-18 mounting stud. The lamp is not case grounded and has two screw terminals on the back to power the lamp.

Some worksites require fog lamps for machines because of working conditions. It is the customer's responsiblitlity to determine if these fog lamps are acceptable and provide the light output necessary for their worksite.

Caterpillar Information System:

1993/10/11 New Connecting Rod Identification Used On Engines {1218}

1993/10/11 New O-ring Seal Used On Cylinder Block Covers {1200}

1993/10/11 New 9U7360 Piston Ring Groove Gauge Group Available {0763,1214,1215}

1993/10/11 Cleaning Kit Available For High Performance Marine Engine Air Filters {1054}

1993/10/11 Fuel Consumption Versus Ambient Temperature {0374,0375,1000}

1993/10/11 Parts Manual Maintenance Parts Page Improved {0374}

1993/10/11 New Freon Compressor Mounting Bracket Used {1154,1802}

1993/10/04 New Product Support Update - 3500 Family Of Engines - Special Edition Service Magazine, SEPD0168 {0374}

1993/10/04 New Main Bearings Have Higher Fatigue Strength {1203,1200}

1993/10/04 New Oil Drain Valve Assembly Prevents Oil Leaks {1302}

1993/10/04 New Crankshaft Seal Groups Prevent Oil Lip Damage {1160,1161}

1993/10/04 New Cylinder Liner And Seal Eliminates Use Of Sealant {1216}

1993/10/18 New Cylinder Head, Spacer Block, And Head Gasket Available {1101,1124,1221}

1993/10/18 Longer Bolts Required With New Spacer Block {1124}

1993/10/25 Air Filter Indicator Maintenance{7452}

1993/10/25 Camshaft Drive Gear Inspection{1212}

1993/11/01 On Highway Dynamic Engine Response Test{1000}

1993/11/01 Low Power Complaints Caused By 9X7793 Rack Sensor Non-Linearity On Electronic Engines{1911}

1993/11/01 New Inlet Valve Lash Setting{1105}

1993/11/09 Improved Window Seals And Sealing Procedure Used On Most Caterpillar Machines{7300,7310}

1993/11/09 New Dynamic Fuel Ratio Control (FRC) Settings Provide Improved Engine Response{1278}

1993/11/09 New Cylinder Block Groups Have Additional Material Added To The Camshaft Bore Area{1201}

1993/11/15 New Fuel Injection Lines, Clamps, And Brackets Used In Fuel Injection Lines Groups {1252}

1993/11/22 8T-8697 Electronic Control Analyzer Programmer (ECAP) Improved{1900}