Traction Control System (TCS) - Test
Show/hide table
| |
| Illustration 1 | g02751878 |
|
"Traction Control Test" Switch, located on overhead console. | |
This functional test is used as an aid in troubleshooting. This test is used in order to verify the operation of the traction control system (TCS). The machine must be stationary with the parking brake in the released position. Service personnel should monitor the hydraulic brake oil pressure for the correct operation.
- Chock the tires and release the parking brakes.
- Install two pressure gauges on the TCS valve.
- Actuate the retarder lever and depress the TCS test switch simultaneously.
- Watch for a decrease in left brake pressure and an increase in left brake pressure. After a short pause, watch for a decrease in the right brake pressure and an increase in the right brake pressure. The test will repeat while the TCS test switch and the retarder lever are in the ENGAGED position.
Note: The test of the traction control system will terminate if a fault is detected during the test. Follow the instructions that are being displayed on the ET screen in order to complete this procedure.
Caterpillar Information System:
Cat® Command for Dozing, Remote Control Operator Station Operator Station - Check - Daily
789D and 789D XQ Off-Highway Truck Air System and Brakes Air Compressor Governor
299D and 299D XHP Compact Track Loaders, 297D and 297D XHP Multi Terrain Loaders and 272D and 272D XHP Skid Steer Loaders Engine Supplement Engine - Install
299D and 299D XHP Compact Track Loaders, 297D and 297D XHP Multi Terrain Loaders and 272D and 272D XHP Skid Steer Loaders Engine Supplement Engine - Remove
299D and 299D XHP Compact Track Loaders and 272D and 272D XHP Skid Steer Loaders Machine Systems Piston Pump (Hydrostatic)
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install - Filter Bypass
793F CMD Off-Highway Truck Steering Electronic Control System Service Tools
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
299D and 299D XHP Compact Track Loaders and 272D and 272D XHP Skid Steer Loaders Machine Electronic Control System Diagnostic Capabilities
773G and 775G OFF-Highway Trucks Engine Supplement Clean Emissions Module - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
Installation of the 2Q-8782 Rear View Camera Kit on the 814F Wheel Dozer, 815F Soil Compactor, and 816F Landfill Compactor{1408, 7348, 7490} Installation of the 2Q-8782 Rear View Camera Kit on the 814F Wheel Dozer, 815F Soil Compactor, and 816F Landfill Compactor{1408, 7348, 7490}
439-3938, 439-3939, 439-3940, 439-3941, 439-3942, 439-3943 Link Bracket Assemblies {0374, 0599, 0632, 0700, 7000} 439-3938, 439-3939, 439-3940, 439-3941, 439-3942, 439-3943 Link Bracket Assemblies {0374, 0599, 0632, 0700, 7000}
C13, C15, and C18 Tier 4 Final Engines Air Lines
® for Dozing, Semi-Autonomous Tractor System (SATS) Off Board Radio - Check
R3000H Load Haul Dump Differential and Final Drive Oil (With Axle Oil Cooler) - Change
777G Off-Highway Truck Oil Filter (Steering Pump Case Drain) - Replace
777G Off-Highway Truck Radiator Core and Aftercooler - Clean
521B and 522B Track Feller Bunchers Machine Systems Travel Pedals - Calibrate
789D and 789D XQ Off-Highway Truck Air System and Brakes Air Tank (Primary)
299D and 299D XHP Compact Track Loaders and 272D and 272D XHP Skid Steer Loaders Machine Systems Gear Motor (Fan, Demand)
815K Soil Compactor and 816K Landfill Compactor Systems Accumulator
793F CMD Off-Highway Truck/Tractor Braking System MID 116 - CID 0190 - FMI 02