Motor Rotating (Brake Cooling) - Extra Retarding
Show/hide table
Illustration 1 | g01954239 |
(1) As required, use the following shims in order to obtain the dimension (A):
- (A) Dimension ...
99.4 to 99.5 mm (3.91 to 3.92 inch) - Thickness of the 9T-2581 Shim ...
0.10 mm (0.004 inch) - Thickness of the 9T-2581 Shim ...
- Thickness of the 9T-2582 Shim ...
0.3 mm (0.01 inch)
Note: Apply 4C-4030 Thread Lock Compound to the threads of the screws (2).
(2) Torque for seven screws ...
(3) 166-7410 Spring
- Free length ...
36.50 mm (1.437 inch) - Outside diameter ...
15.30 mm (0.602 inch) - Outside diameter ...
(4) As required, use any one of the following shims in order to obtain the clearance (B):
- (B) Clearance ...
0.20 ± 0.05 mm (0.008 ± 0.002 inch) - Thickness of the 141-0247 Shim ...
3.50 mm (0.138 inch) - Thickness of the 141-0247 Shim ...
- Thickness of the 141-0248 Shim ...
3.60 mm (0.142 inch)
- Thickness of the 141-0249 Shim ...
3.70 mm (0.146 inch)
- Thickness of the 141-0250 Shim ...
3.80 mm (0.150 inch)
- Thickness of the 141-0252 Shim ...
4.00 mm (0.157 inch)
Caterpillar Information System:
797F and 797F XQ Off-Highway Truck Braking System Piston Motor (Brake Cooling) - Extra Retarding
797F and 797F XQ Off-Highway Truck Power Train Gear Pump (Brake, Rear Axle Lubrication) - Extra Retarding
2009/08/03 Special Instruction for the Heated Body Kit is Available for Articulated Trucks {1061}
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Fill Time for the Transmission Clutch - Calibrate
584 and 584HD Forwarders Camera - Clean/Adjust - If Equipped
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Engagement Pressure for the Transmission Clutch - Calibrate
793F Off-Highway Truck Power Train Axle Shaft - Remove
793F and 797F Off-Highway Trucks Power Train Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
2009/09/28 New Software Released For AccuGrade Office {5267, 7220}
2009/12/23 Improved Seals for the Service Brake are Available for the 797, for the 797B, and for Certain 797F Off Highway Trucks {4251, 4267}
2009/07/27 Improved Procedure for the Retention of the Identification Film for the Roll Over Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) {7323, 7325, 7405, 7557}
2009/10/29 Improvements for Sealing the Inner Wheel Seal and the Outer Wheel Seals {4008, 7561}
797F and 797F XQ Off-Highway Truck Power Train Gear Pump (Brake Cooling, Brake Actuation and Rear Axle Motor Drive)
797F and 797F XQ Off-Highway Truck Braking System Piston Pump (Brake Cooling) - Extra Retarding
793F Off-Highway Truck Power Train Transmission and Transfer Gears - Remove and Install
CD44B and CD54B Vibratory Asphalt Compactors Alternator - Inspect
2009/08/03 Pistons and Piston Rings {1225, 1225}
M325D L MH and M325D MH Material Handlers Hydraulic System Swing Bearing Movement - Measure
2009/07/20 Method for Monitoring The Landfill Compactor Tip Assembly ( 7 inch step ) {4206, 6806}
2011/01/06 Improvements to the Fuel Sender Group {1273, 1408, 6201, 7481, 7857}
2009/07/27 New Bumpers Are Now Used on Cab Doors {7308}
770 and 772 Off-Highway Truck Camera - If Equipped
2009/09/07 Rework Procedure to Reinforce the Mounting of the Cowl {7051, 7155, 7251, 7254, 7267}
Rework Procedure to Reinforce the Cowl Assembly{0679, 7051, 7155, 7251, 7254, 7267} Rework Procedure to Reinforce the Cowl Assembly{0679, 7051, 7155, 7251, 7254, 7267}