Air Compressor Governor - Test and Adjust
Show/hide table
打开排放阀时,请穿戴防护手套、防护面罩、防护衣和防护鞋。 压缩空气可能会将杂质吹出并造成人身伤害。 |
Show/hide table
注意 |
---|
不要超过830 ± 35 kPa (120 ± 5 psi)空气压力,否则会发生空气系统部件的损坏。 |
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 8T-0849     | 压力表     | 1     |
调整调节器之前,完成步骤 1 至步骤 8。
- 释放气罐中的空气压力。
- 将测压口安装在储气罐的排放阀中。
- 将工具 (A) 安装在测压口上。
- 使用外部气源对空气系统充气。
- 起动发动机。
- 记录切断调节器时的空气压力。
- 反复打开罐放出口,直至空气压力下降并且调节器激活。
- 记录接入压力。 如果切断压力不是 837 ± 34 kPa (120 ± 5 psi)并且接入压力不是 655 kPa (95 psi),则调整调节器。
- 拆下调节器顶部的盖 (1) 。
Show/hide table
图 1 | g02163319 |
调节器组件 |
注: 调节器组件位于压缩机总成的前部。
- 松开盖下方调整螺钉的锁紧螺母。
- 逆时针转速调整螺钉,以便将切断压力设定值增加至 837 ± 34 kPa (120 ± 5 psi)。 如果需要降低切断压力设定值,则要顺时针转动调整螺钉。
- 上紧调整螺钉的锁紧螺母以保持这一调整值。
调整调节器之后,检查切断压力。 如果切断压力没有变化,则检查卸荷阀有无损坏。 如果切断压力与接入压力之间的差值不在技术规范的范围之内,则检查调节器有无损坏。
检查机器上的气压表。 检查安装在一次空气管排放阀内的测试仪表。
起动发动机。 运转发动机,直至达到切断压力。 气压表上的指示必须与测试仪表上的指示相等。 如果差值超过 35 kPa (5 psi),则在机器上安装一个新压力传感器。
Caterpillar Information System:
793F and 793F CMD Off-Highway Truck Air System Air Dryer - Check
793F and 793F CMD Off-Highway Truck Air System Air Compressor - Check
793F and 793F CMD Off-Highway Truck Air System Air System Troubleshooting
793F and 793F CMD Off-Highway Truck Air System Operational Checks
793F and 793F CMD Off-Highway Truck Air System Visual Inspection
793F and 793F CMD Off-Highway Truck Air System Air Horn
793F and 793F CMD Off-Highway Truck Air System Air Tank
793F and 793F CMD Off-Highway Truck Air System Air Dryer
793F and 793F CMD Off-Highway Truck Air System Air Compressor
416E, 420E and 430E Backhoe Loaders Hydraulic and Steering System Control Manifold and Solenoid (Boom, Stick, Pattern Switch)
2008/05/26 A New Ball Bearing Is Used in the Torque Converter {3101}
414E, 416E, 420E and 430E Backhoe Loaders Machine Systems Backhoe Bucket Linkage - Remove and Install
2008/05/19 Improved Drive Shaft Groups Increase Loading Capability {1017, 1157, 1207, 3108, 3253, 5070, 5073}
414E, 416E, 420E and 430E Backhoe Loaders Machine Systems Lift Arms - Remove
414E, 416E, 420E and 430E Backhoe Loaders Machine Systems Lift Arms - Install
773F and 775F Off-Highway Truck Hoist and Brake Tank Oil Sample - Obtain
793F and 793F CMD Off-Highway Truck Air System Solenoid Valve (Air Start)
414E, 416E, 420E and 430E Backhoe Loaders Machine Systems Lift Cylinder - Remove and Install
CB-434D, CB-534D and CB-564D Asphalt Compactors Propel Speed Range Control - Test
2008/05/05 The Margin Pressure Adjustment Plug for the Pump Control Valve Has Been Improved {5070, 5455}
414E, 416E, 420E and 430E Backhoe Loaders Machine Systems Tilt Cylinder - Remove and Install
793F and 793F CMD Off-Highway Truck Hydraulic System Hoist Cylinder
416E, 420E and 430E Backhoe Loaders Machine Systems Bucket - Remove and Install
2008/05/05 New Software for the Caterpillar Monitoring System is Now Available {7490, 7620}