Stopping the Engine if an Electrical Malfunction Occurs
如果发动机断开/接通/起动开关不能停止发动机,执行以下程序:
- 确保机器完全停下来。 确保换挡操纵杆处于 P 位置。
Show/hide table
图 1 g03405361 所示的地平面控制箱盖子处于打开状态。 - 打开地平面控制箱上的盖子 (1)
- 升起护罩 (2)。
- 把发动机停机开关 (3) 向上移到停机位置。
注: 在故障未排除之前不要再操作机器。 排除故障后,把发动机停机开关置于运转(RUN)位置。 降下护罩将把扳钮开关转到运转位置。
Caterpillar Information System:
CB-434D, CB-534D and CB-564D Asphalt Compactors Propel Control Position Sensor - Test
D6K Track-Type Tractor Fuel System Secondary Filter - Replace
AP600D and BG600D Asphalt Pavers Propel System Rotary Position Sensor (Steering) - Calibrate
2590 Track Feller Buncher Machine Systems Swing Motor Relief Valve Pressure - Test and Adjust
AP600D and BG600D Asphalt Pavers Propel System Reverse Currents (EDC)- Calibrate
416E Backhoe Loader Work Tool Flow Control - If Equipped
AP600D and BG600D Asphalt Pavers Propel System Forward Currents (EDC)- Calibrate
CB-434D, CB-534D and CB-564D Asphalt Compactors Parking Brake Switch - Test
904B, 906 and 908 Compact Wheel Loaders, IT14G and IT28G Integrated Toolcarriers and 914G, 924G, 924GZ, 928G and 930G Wheel Loaders Steering Column Spline (HMU Steering) - Lubricate
PL61 Pipelayer Monitoring System System Schematic
C7 PETROLEUM Petroleum Engine Crankshaft Rear Seal - Install
AP600D and BG600D Asphalt Pavers Propel System Propel Lever - Calibrate
C4.4 and C6.6 Engines for Caterpillar Built Machines Data Link Circuit - Test
Procedure to Shorten Fumes Disposal Tube on 527 Track-Type Skidder{1317} Procedure to Shorten Fumes Disposal Tube on 527 Track-Type Skidder{1317}
C4.4 and C6.6 Engines for Caterpillar Built Machines Electrical Connectors - Inspect
24M Motor Grader Hydraulic System Oil - Change - Alternate Viscosity
CB-334E and CB-335E Paving Compactors Maintenance Interval Schedule
AP600D and BG600D Asphalt Pavers Propel System Pressure Limiter Valve - Test and Adjust
CB34, CB34XW and CC34 Utility Compactors Water Spray Check Valve - Clean
CB34, CB34XW and CC34 Utility Compactors Additive Spray System - Drain
2008/04/14 Increased Support for Repair Parts is Available for Products that are sold by Dealer Service Tools from Advanced Technology Services {0599}
2008/03/17 Updated Instruction For The Bypass Harness {0785, 1408}
2008/03/17 An Improved Boom Is Now Available for Certain E-Series Backhoe Loaders {6501}
Transmission Clutch Plates and Disc Assemblies with Rayflex Friction Material {3030, 3155, 3190} Transmission Clutch Plates and Disc Assemblies with Rayflex Friction Material {3030, 3155, 3190}