3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Caterpillar


Engine Speed/Timing Sensor

Usage:

785C 1HW


图 1g02587517

表 1
技术规格 - 273-5041 发动机转速 / 正时传感器总成 
项目  数量  零件  技术规格说明 
拧紧至扭矩为 40 ± 5 N·m (30 ± 4 lb ft)。 
      工作电压为 7.5 至 14 VDC。 
      输出频率为 9 Hz 至 10 kHz。 

Caterpillar Information System:

2008/12/15 Correction to Systems Operation , "Power Train Electronic Control System" {4800, 7610}
2007/12/24 An Improved Pump Control Valve Is Available for the High Flow Work Tool Pump on Certain Multi Terrain Loaders and Skid Steer Loaders {5070, 5455}
2008/02/04 Correction to Systems Operation , "Power Train Electronic Control System" {4800, 7610}
R1700G Load Haul Dump Before Starting Engine
2007/12/17 A New Lens is Available for the Rear Tail Lamp {1429, 1434}
450E Backhoe Loader Hydraulic and Steering System Multipurpose Bucket Cylinder
24M Motor Grader Engine Supplement Muffler - Remove and Install
2010/10/13 Four Bearings Are Now Used On the Hydraulic Control Support (Armrest) {5258}
24M Motor Grader Machine Systems Oil Filter and Base (Hydraulic) - Install - Power Train
24M Motor Grader Power Train Relief Valve - Assemble - Differential Lock
24M Motor Grader Power Train Relief Valve - Disassemble - Differential Lock
CB22, CB24, CB32 and CC24 Utility Compactors Water Spray Check Valve - Clean
3508B Engine for Caterpillar Built Machines Crankcase Breather
24M Motor Grader Machine Systems Bottom Guard - Remove and Install
PM-201 Cold Planer Machine Systems Track - Separate
PM-201 Cold Planer Machine Systems Track - Connect
450E Backhoe Loader Diagnostic Code List
C4.4 and C6.6 Engines for Caterpillar Built Machines Sensors and Electrical Connectors
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Wiring Information
450E Backhoe Loader MID 039 - CID 0041 - FMI 03
C175-16 Locomotive Engine Electric Starting Motor
450E Backhoe Loader MID 039 - CID 0041 - FMI 04
PM-201 Cold Planer Machine Systems Conveyor Idler (Second Stage) - Remove and Install
2008/05/12 An Improved Pinion Shaft with a New Rugged Bolted Joint Provides Consistent Torque on the Circle Drive {5207}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.