Access Codes for the IQAN MDL System{7490, 7600}
- Track Feller Buncher:
- 511 (S/N: 5111-UP)
- 521 (S/N: 5211-UP)
- 522 (S/N: 5221-UP)
- 532 (S/N: 5321-UP)
- 541 (S/N: 5411-UP)
- 551 (S/N: 5511-UP)
- 552 (S/N: 5521-UP)
- 1090 (S/N: BZJ2110-UP)
- 1190 (S/N: BZK2160-UP)
- 1190T (S/N: BZL2110-UP)
- 1290T (S/N: BZM2260-UP)
- 1390 (S/N: B3F2310-UP)
- 521 (S/N: 5211-UP)
Introduction
Access codes are needed to access IQAN MDL functions.
Note: The information that is contained in this publication is intended for dealers only.
Problem
Codes are needed to access certain areas of the new IQAN MDL system that is used on the Track Feller Bunchers that are listed above.
Solution
Use the following codes to access the IQAN MDL functions:
Show/hide table
Illustration 1 | g01427595 |
Show/hide table
Function     | Access Code for Caterpillar Machines     | Access Code for Prentice Machines     |
"Hyd & Fuel Sensors"     | 4532     | 2002     |
"Joystick Calibration"     | 4532     | 2002     |
"Travel Pedal Calibration"     | 4532     | 2002     |
"Joystick Configuration 1"     | 5957     | 1874     |
"Joystick Configuration 2"     | 5957     | 1874     |
"Vehicle Definition"     | 5957     | 1874     |
"Vehicle Settings"     | 5957     | 1874     |
"Powershift Settings"     | 5957     | 1874     |
Caterpillar Information System:
14M and 16M Motor Graders Power Train Wheel and Mounting
C18 Engines for Caterpillar Built Machines Coolant Level Sensor Circuit - Test
RM-300 Reclaimer Mixer Machine Systems Suspension Bar (Mixing Chamber Linkage) - Remove and Install
RM-300 Reclaimer Mixer Machine Systems Rubber Spring (Suspension Bar/Mixing Chamber Linkage) - Remove and Install
RM-300 Reclaimer Mixer Machine Systems Position Sensor (Rear Steering) - Remove and Install
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 0573 - FMI 08
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 0573 - FMI 04
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 0573 - FMI 03
2006/07/31 Orifices Are Available for a Worn Bore in the Pump Actuator {5070, 5078}
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Hydraulic and Steering System Metering Pump (Steering)
450E Backhoe Loader Engine Oil Level - Check
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Hydraulic and Steering System Control Manifold (Pilot Operated) - Outlet Manifold for the Backhoe
2006/08/07 A New Kit for the Cooling System Pressure Cap is Available {1353, 1354, 1382, 1392, 7405}
CB-534D and CB-564D Asphalt Compactors Safety Messages - Arrangement II
2006/10/09 The Lubrication to the Bearings has been Improved {3030, 3160}
966H and 972H Wheel Loaders Drive Shaft Universal Joints - Lubricate
120M, 12M, 140M and 160M Motor Graders Rear Axle
120M, 12M, 140M and 160M Motor Graders Wheel Group
450E Backhoe Loader Engine Oil Sample - Obtain
2006/07/10 Special Instruction, REHS2251 , "A Procedure for Installing an Improved Variable Frequency Controller on Large Soil Compactors" is Now Available With an Electrical Schematic for the Variable Frequency Controller {5258}
450E Backhoe Loader Engine Oil and Filter - Change
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 1407 - FMI 03
246C, 256C, 262C and 272C Skid Steer Loaders Operation Information
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 1407 - FMI 05