RM-500 Soil Stabilizer Caterpillar


Daily Inspection

Usage:

RM-500 ASW

------ WARNING! ------

即使是从针孔大小的渗漏中漏出的空气或液体,都能够穿透人体组织而造成严重创伤,甚至死亡。 如果液体喷射穿透进您的皮肤,必须立即找熟悉这类型创伤的医生处置。

检查渗漏时,请务必使用木板或硬纸板作为挡板。



注意

机器上积聚的润滑脂和润滑油有引发火灾的危险。 至少每1000小时或每当有大量的油溢出机器时,用蒸汽或高压水清除这些脏物。


在维修机器前,擦净所有的接头、所有的盖和所有螺塞。

注: 细致观察是否有渗漏。 如果观察到有泄漏,找到泄漏的源头。 修复泄漏。 如果怀疑有泄漏,比推荐的周期更频繁地检查液位。

  1. 检查粗滤清器有无脏物堆积。 如果脏物堆积,清洁粗滤清器。



    图 1g01207742

    空气滤清器保养指示器的位置




    图 2g01211486

  1. 当发动机在快速怠速时,记下指示器的位置。 当黄色柱塞进入红色区域时,保养空气滤清器。

    注: 在保养空气滤清器前,停止发动机。

  1. 检查机器有无松动的接线。 检查机器有无破损的接线。

  1. 检查灯泡有无损坏。 检查灯玻璃有无损坏。 如果发现灯泡或玻璃损坏,就需要对它们进行更换。

  1. 打开所有检视盖。 检查各室有无堆积的脏物。 清除各室的任何脏物。

  1. 检查液压系统是否泄漏。 检查液压油箱、软管、管、螺塞和接头有无泄漏或损坏。 修理任何损坏的地方。 修理任何泄漏的地方。

  1. 所有盖和挡板必须牢固就位。 检查所有盖和挡板有无损坏。 修理任何损坏的地方。



    图 3g01151379

    典型实例




    图 4g01151399

    典型实例

  1. 检查阶梯、通道和扶手有无损坏或磨损。 修理损坏或磨损的部件。 检查阶梯、通道和扶手是否清洁。 清洁部件。

  1. 检查驾驶室内是否干净。 驾驶室要保持清洁。

  1. 每日对机器进行适合的保养程序:

    • 操作和保养手册, "倒车报警器 - 测试"

    • 操作和保养手册, "承梁摆动销(后部) - 润滑"

    • 操作和保养手册, "冷却系统液位 - 检查"

    • 操作和保养手册, "发动机机油油位 - 检查"

    • 操作和保养手册, "液压系统油位 - 检查"

    • 操作和保养手册, "指示器和仪表-测试"

    • 操作和保养手册, "停放制动器 - 检查"

    • 操作和保养手册, "滚筒轴承储油箱油位 - 检查"

    • 操作和保养手册, "滚筒切割刀头 - 检查/更换"

    • 操作和保养手册, "滚筒切割刀头(侧部) - 检查/更换"

    • 操作和保养手册, "座椅安全带 - 检查"

    • 操作和保养手册, "轮胎充气 - 检查"

Caterpillar Information System:

IQAN MDL Control and Monitoring System Show Application Information
793D Off-Highway Truck Hydraulic Fan System Makeup Valve (Hydraulic Fan Motor)
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Hydraulic and Steering System Swing Cylinder
RM-500 Soil Stabilizer Specifications
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Work Tool Flow Control - If Equipped
AP-1000D and BG-260D Asphalt Pavers Machine Systems Steering Valve
RM-500 Soil Stabilizer Safety Messages
3512C Engine for 785D Off-Highway Truck/Tractors Engine Design
3512C and 3516C Marine Engines Engine Design
430E Backhoe Loader Mounting and Dismounting
R1300G Series II Load Haul Dump Hydraulic System General Information
R1300G Series II Load Haul Dump Hydraulic System Selector and Pressure Control Valve
950H Wheel Loader, 962H Wheel Loader and IT62H Integrated Toolcarrier Electrohydraulic System Control Valve (Lift)
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Auxiliary Water Pump - Assemble
793D Off-Highway Truck Hydraulic System Gear Pump (Hoist, Brake Release, Oil Cooling)
RM-500 Soil Stabilizer Operator Controls
CB-534D, CB-534D XW and CB-564D Vibratory Compactors Machine Systems Brake Pump - Remove and Install
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Electrical Connectors - Inspect
793D Off-Highway Truck Steering System Solenoid Valve and Manifold (Rear Axle Fan, Lubrication, Steering) - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner
3516B Off-Highway Trucks System Configuration Parameters
RM-500 Soil Stabilizer Operator Interlocks
IQAN MDL Control and Monitoring System Show Module Information
2005/10/03 Starting the Engine with Jumper Cables on Machines with an Electric Starter {1000, 7000}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.