Electronic Control Module (ECM) - Replace
Prior to the replacement of the ECM, ensure that replacement is absolutely necessary. The ECM is seldom the cause of a failure. Always check that power is available to all of the contacts of the ECM that are marked with "+ Battery" and "Keyswitch". Continue Only if all other attempts to isolate the problem have failed. Always consult the dealership's Technical Communicator for possible consultation with Caterpillar. This consultation may greatly reduce the time required for a repair.
Perform the following in order to replace the ECM:
- Disable the supply voltage to the system and confirm no voltage is present at the PL1000E Communication ECM connector.
- Disconnect the system harness from the ECM.
- Remove the ECM.
- Make sure that the replacement ECM is the correct part number.
- Install the replacement ECM according to the procedures in Special Instruction, REHS2362.
- Verify that the ECM operates correctly.
Caterpillar Information System:
TH220B, TH330B and TH340B Telehandlers Machine Systems Boom Cylinder
AccuGradeTM - Grade Control System (GPS/ATS/Sonic/Cross Slope) Automatic Control System
PL1000E Communication ECM Electronic Control Module (ECM) - Flash Program
TH220B, TH330B and TH340B Telehandlers Machine Systems Boom Cylinder
TH210 and TH215 Telehandlers Machine Systems Boom Cylinder - Remove and Install
735, 740 and 740 EJECTOR Articulated Trucks Engine Supplement Radiator Guard - Install
735, 740 and 740 EJECTOR Articulated Trucks Engine Supplement Radiator Guard - Remove
735, 740 and 740 EJECTOR Articulated Trucks Engine Supplement Radiator - Remove
735, 740 and 740 EJECTOR Articulated Trucks Engine Supplement Aftercooler, Fan, and Gear Motor - Install
2005/05/30 The Parking Brake Control Group Has Been Updated with an Updated Plate, Updated Plate Assembly and New Specifications Which Improve Reliability {4282, 4284}
735, 740 and 740 EJECTOR Articulated Trucks Engine Supplement Suction Fan and Gear Motor (Hydraulic Fan) - Install
AccuGradeTM - Grade Control System (GPS/ATS/Sonic/Cross Slope) System Components
TH220B, TH330B and TH340B Telehandlers Machine Systems Boom Cylinder
950K Wheel Loader and 962K Wheel Loader Steering System Piston Pump (Steering)
TH210 and TH215 Telehandlers Machine Systems Compensating Cylinder - Remove and Install
Bench Test Procedure for Hydraulic Piston Pumps{3203, 5070} Bench Test Procedure for Hydraulic Piston Pumps{3203, 5070}
793D Off-Highway Truck/Tractor Air/Hydraulic Cylinder (Front Brake) - Remove
793D Off-Highway Truck/Tractor Air/Hydraulic Cylinder (Rear Brake) - Remove
2005/06/06 Special Instruction, REHS2624 , "Instructions for Converting Hot Saw to Intermittent Saw " Is Available {5051, 5051, 5057, 6543}
CB-434D, CB-534D, CB-534D Series XW and CB-564D Paving Compactors Traction Control System
TH210 and TH215 Telehandlers Machine Systems Boom - Remove
C9 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
793D Off-Highway Truck/Tractor Door Panel (Left) - Remove and Install
793D Off-Highway Truck/Tractor Door Panel (Right) - Remove and Install