Fuel Shutoff Solenoid - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect electrical connections (3) to the fuel shutoff solenoid (1). Mark all connections for later installation.
- Remove fuel shutoff solenoid (1) from the fuel injection pump housing by rotating the fuel shutoff solenoid in a counterclockwise direction.
- Remove the O-ring (2) from fuel shutoff solenoid (1).
Show/hide table
| |
| Illustration 1 | g00824952 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Check the condition of O-ring seal (2). If the O-ring seal is worn or damaged use a new part for replacement.
- Install fuel shutoff solenoid (1) into the fuel injection pump housing by rotating the fuel shutoff solenoid in a clockwise direction. Tighten the fuel shutoff solenoid to a torque of
17 N·m (12 lb ft) . - Reconnect electrical connection (3) to fuel shutoff solenoid (1) before you operate the engine.
Show/hide table
|
| |
| Illustration 2 | g00824952 |
Caterpillar Information System:
C7 Engines for Caterpillar Built Machines Electronic Control System Components
735, 740 and 740 EJECTOR Articulated Trucks Power Train Final Drive and Wheel
C7 Engines for Caterpillar Built Machines General Information
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Braking System Brake System Troubleshooting
14M and 16M Motor Graders Transmission Pressures - Test and Adjust
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Filter Base - Install
Supplemental Parts Information for the USN Seabee IT28G{0600, 1405, 4202, 4209, 5050, 5051, 5067, 5069, 5117, 6402, 7000, 7056} Supplemental Parts Information for the USN Seabee IT28G{0600, 1405, 4202, 4209, 5050, 5051, 5067, 5069, 5117, 6402, 7000, 7056}
AP-1055D and BG-2455D Asphalt Pavers Conveyor Planetary Drive (Drag) Oil - Change
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Final Drive Planetary (Auger Conveyor) - Remove
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Pressure Switch (Refrigerant Pressure Cutoff)
735, 740 and 740 EJECTOR Articulated Trucks Power Train Final Drive and Wheel
854G Wheel Dozer Lubricant Viscosities
AP-1055D and BG-2455D Asphalt Pavers Conveyor Planetary Drive (Drag) Oil Level - Check
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Auger Conveyor - Remove and Install
AP-1055D and BG-2455D Asphalt Pavers Conveyor Planetary Drive (Drag) Oil Sample - Obtain
AP-1055D and BG-2455D Asphalt Pavers Conveyor System - Inspect
583T Pipelayer Power Train Pivot Shaft - Remove and Install
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Final Drive Planetary (Auger Conveyor) - Install
834H Wheel Dozer and 836H Landfill Compactor Steering System General Information
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Hydraulic Cylinder (Auger Hoist) - Remove and Install
TH580B Telehandler Machine Systems Frame Leveling Cylinder - Remove and Install
Assembly Procedures for 784C Tractors and 785C Off-Highway Trucks {7000, 7006, 7960} Assembly Procedures for 784C Tractors and 785C Off-Highway Trucks {7000, 7006, 7960}
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Braking System Service Brakes
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Braking System Brake Accumulator - Test and Charge