Removal Procedure
- Install the frame lock pin.
- Remove bolt (2), pin assembly (1), and bushing (3) .
 | |
| Illustration 1 | g01094381 |
- Disconnect hose assemblies (4) from hydraulic cylinder (5) .
 | |
| Illustration 2 | g01094386 |
- Remove bolt (6), pin assembly (7), and the bushing.
 | |
| Illustration 3 | g01103758 |
- Remove hydraulic cylinder (5) .
 |
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed. Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death. Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder. |
 |
Disassembly and Assembly Information
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 127-4904 | Repair Stand | 1 |
| B | 1P-0808 | Multipurpose Grease | 1 |
| C | 195-4609 | Seal Pick | 1 |
 | |
| Illustration 4 | g01100585 |
(1) Apply Tooling (B) to the seal groove prior to assembling the wiper seal.
(2) Lubricate sealing lips with a thin covering of the lubricant that is being sealed.
Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install hydraulic cylinder (5). Connect hose assemblies (4) .
| | |
| Illustration 5 | g01094386 |
- Install the bushing, pin assembly (7), and bolt (6) .
| | |
| Illustration 6 | g01103758 |
- Connect hose assemblies (4) .
- Install bolt (2), pin assembly (1), and bushing (3) .
| | |
| Illustration 7 | g01094381 |
- Remove the frame lock pin.