Removal Procedure
Show/hide table
Table 1
| Required Tools |
| Tool |
Part Number |
Part Description |
Qty |
| A |
4C-9416 |
Wrench Assembly |
1 |
| ZZ |
6V-9508 |
Face Seal Plug (11/16 - 16 THD) |
6 |
| 6V-9829 |
Cap Assembly (11/16 - 16 THD) |
6 |
Start By:
- Remove the platform. Refer to Disassembly and Assembly, "Platform - Remove and Install".
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Show/hide table
|
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
|
Show/hide table
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
Show/hide table
|
 |
|
| Illustration 1 | g01067346 |
- Disconnect hose assemblies (1) .
Show/hide table
|
 |
|
| Illustration 2 | g01067361 |
- Disconnect hose assemblies (2) .
- Disconnect harness assemblies (3) .
Show/hide table
|
 |
|
| Illustration 3 | g01067359 |
- Remove bolts (4) .
- Remove cover plate (5) .
Show/hide table
|
 |
|
| Illustration 4 | g01067364 |
- Disconnect hose assemblies (6) .
Show/hide table
|
 |
|
| Illustration 5 | g01067365 |
- Remove cable strap (7) .
Show/hide table
|
 |
|
| Illustration 6 | g01067367 |
- Bend down the bearing lockwasher (8) .
- Use Tooling (A) in order to remove bearing locknut (9) . Remove bearing lockwasher (8) , and use Tooling (A) in order to remove bearing locknut (10) .
Show/hide table
|
 |
|
| Illustration 7 | g01067368 |
- Remove bolts (11) and (13) .
- Remove pin (12) .
Show/hide table
|
 |
|
| Illustration 8 | g01071087 |
- Disconnect harness assembly (14) from control box (15) .
Show/hide table
|
 |
|
| Illustration 9 | g01067369 |
- Attach a suitable lifting device to extender carriage (16) . Pull extender carriage (16) to the left approximately three feet. Remove the suitable lifting device.
Show/hide table
|
 |
|
| Illustration 10 | g01067370 |
- Attach a suitable lifting device to extender carriage (16) and remove extender carriage (16) from the screed. The weight of the extender carriage is approximately 657 kg (1450 lb).
