Aftercooler - Disassemble
开始:
- 拆下后冷器。
- 拆下螺栓 (1)、螺栓 (2) 和底盖 (3)。
Show/hide table
图 2 g03836790 - 拆下密封 (4)。
Show/hide table
图 3 g03836995 - 拆下螺栓 (5)、螺栓 (6) 和底盖 (7)。
Show/hide table
图 4 g03837202 - 拆下密封 (8)。
Show/hide table
| |
| 图 1 | g03836740 |
Caterpillar Information System:
3512C and 3516C Industrial Engines Air Lines
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Engine Oil Filter
3500 Industrial Engines Fuel Injector Mechanism
Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490} Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490}
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Left-Hand Service Oil
3516B Generator Set Engines with Dynamic Gas Blending Exhaust System Contains Oil
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Combined Circuit Keel Cooling
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Right-Hand Service
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Air Inlet Shutoff - Remove and Install
C9.3 Marine Engine Fuel Pressure Sensor - Remove and Install
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C9.3 Marine Engine Inlet Manifold Temperature Sensor - Remove and Install
C9.3 Marine Engine Inlet Manifold Pressure Sensor - Remove and Install