- Caterpillar Products
- All
Introduction
This Special Instruction describes the procedure to flash the ADEM 3 Engine Electronic Control Gp.
Read the entire Special Instruction. Do not perform any procedures or order any parts until you have read and understand the information contained in this publication.
Safety Section
 |
|
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Cat dealer for replacement manuals. Proper care is your responsibility. |
|
|
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin. |
Required Parts and Tools
Refer to Table 1 for the affected Electronic Control Modules (ECM) and to Table 2 for the required tools.
| Affected Electronic Control Modules | |
| 10R-3571 | Electronic Control Gp |
| 10R-4090 | Electronic Control Module |
| 10R-4091 | Engine Electronic Control Gp |
| 10R-4092 | Engine Electronic Control Gp |
| 10R-4093 | Engine Electronic Control Gp |
| 10R-4094 | Engine Electronic Control Gp |
| 10R-7706 | Electronic Control Gp |
| 10R-8026 | Engine Electronic Control Gp |
| 10R-7985 | Engine Electronic Control Gp |
| 10R-7987 | Engine Electronic Control Gp |
| 10R-8732 | Engine Electronic Control Gp |
| 10R-7986 | Electronic Control Module |
| 10R-8982 | Engine Electronic Control Gp |
| 10R-7984 | Engine Electronic Control Gp |
| 10R-9484 | Engine Electronic Control Gp |
| |
| Illustration 1 | g03642834 |
| Required Tools | |||
|---|---|---|---|
| Item | Qty | Part Number | Description |
| A | 1 | Wiring Harness (Main) |
|
| B | 1 | Harness (ECM Bypass) |
|
Procedure
Refer to the following steps to load the application into the ECM.
- Verify that the 217-0113 Wiring Harness (A) is connected correctly.
- Plug the 9 Pin connector of the 217-0113 Wiring Harness into the communication adapter.
- Connect the black clip to "- VBatt" on the power supply.
- Connect the red clip to "+ VBatt" on the power supply.
- Connect the 328-2292 Harness (B).
- Turn on the power supply.
Note: Voltage should read between 12V to 24V.
- Launch the Cat® Electronic Technician (Cat ET) Service Tool program.
- Navigate to the "WinFlash" section.
- When the ECM is detected, flash with the appropriate application.
| |
| Illustration 2 | g03642844 |
|
Engine ECM | |
If problems arise during this process, contact the following:
- Contact your Caterpillar Dealers Technical Communicator (TC)
- For additional support, contact Technical Support or Service Technical Support at: