Rocker Arm - Disassemble
Disassembly Procedure
Start By:
- Remove the valve mechanism group. Refer to Disassembly and Assembly, "Valve Mechanism - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (2) and the washers from rocker arm shaft (1) .
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g01297832 |
- Use a paint stick to put identification marks on all of the components for assembly purposes.
- Remove the bolts and plate (4) from one end of rocker arm shaft (1) .
- Remove rocker arms (3) from rocker arm shaft (1) .
- Remove buttons (5). Remove the O-ring seal from buttons (5) .
Show/hide table
Illustration 2 | g01297835 |
Note: O-ring seals hold buttons (5) in place on the rocker arms.
Caterpillar Information System:
2007/10/22 The Programmable Monitoring System Parameters Have New Descriptions {1901, 1902, 7620}
3608 Engine Valve Mechanism - Install
3608 Engine Camshaft - Remove
2007/10/15 An Improved Air Cleaner Assembly is Now Used {1051, 1054}
2007/10/01 A New Base for the Engine Oil Cooler and Engine Oil Filter is Now Used {1306, 1378}
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3608 Engine Idler Gears (Rear) - Install
3608 Engine Idler Gears (Rear) - Remove
3608 Engine Crankshaft Rear Seal - Install
C15 and C18 Petrolem Generator Set Engines Cat Data Link - Test
C15 and C18 Petrolem Generator Set Engines CAN Data Link - Test
3608 Engine Vibration Damper - Remove
C-10 and C-12 Truck Engines Exhaust Manifold
C-10 and C-12 Truck Engines Exhaust Manifold
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
3608 Engine Governor - Remove
3608 Engine Governor - Install
3500B and 3500C Marine Propulsion Engines Engine Will Not Crank
3176C and 3196 Engines for Caterpillar Built Machines Belt Tensioner
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073}
3608 Engine Governor Drive - Assemble - Later
3608 Engine Fuel Injector - Remove
3608 Engine Fuel Injector - Install