Installation Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| B | 8T-0914 (1) | Guide Pin | 2 |
| C | - | Guide Bolts 3/8 - 16 by 5 inch |
2 |
| D | 1P-0808 | Multipurpose Grease | - |
| ( 1 ) | Part of 9U-5105 Engine Tool Group |
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install Tooling (B) in the rear of the crankshaft.
Note: The dash marks on the sleeve in adapter (4) must be aligned with the dash mark on the crankshaft.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
 | |
| Illustration 1 | g01294474 |
- Attach a suitable lifting device to adapter (4). The weight of adapter (4) is approximately 65 kg (143 lb). Place adapter (4) in position on Tooling (B). Install bolts (3) that hold adapter (4) in place.
- Remove Tooling (B) .
- Install Tooling (C) in the flywheel housing.
Note: The crankshaft rear seal must be installed with the lip of the seal toward the inside of the engine. Ensure that the correct seal is installed on each end of the crankshaft.
- Apply Tooling (D) to the O-ring seal on the outside diameter of adapter (1) .
- Place the crankshaft rear seal and adapter (1) on Tooling (C). Carefully slide the crankshaft rear seal and adapter (1) on the flywheel housing.
Note: Ensure that all the parts are clean. Do not touch the lip of the seal. Do not use lubricant on the lip of the seal. Ensure that the arrow on the seal points in the same direction as the crankshaft rotation.
- Install bolts (2) that hold the crankshaft rear seal and adapter (1) in place.
End By: Install the flywheel. Refer to Disassembly and Assembly, "Flywheel and Ring Gear - Remove and Install".