Flywheel Housing
Show/hide table
| |
| Illustration 1 | g02570278 |
|
Rear view | |
Show/hide table
| |
| Illustration 2 | g02570281 |
|
Tightening sequence | |
Show/hide table
| Specification for 304-5277 Flywheel Housing Gp | |||
| Item | Qty | Part | Specification Description |
| - | - | - | Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the rear housing. The components must be free of the following substances: oil, fuel, water, assembly compounds, and any other contaminants. |
| - | - | - | Check assembled installation depth of the crankshaft seal group with the crankshaft in any axial position. |
| - | - | - | Use the following procedure to tighten the flywheel housing bolts. Tighten the bolts in the numerical sequence as shown in the Illustration 2. |
| 1 | 2 | 245-3803 Bolt | Tighten bolt (1) through bolt (2) to |
| 2 | 8 | 2H-6488 Bolt | Tighten bolt (3) through bolt (10) to |
| 3 | 16 | 0L-1143 Bolt | Tighten bolt (11) through bolt (26) to |
| 4 | - | - | The seal driver must not contact the seal within the |
| The seal and the sleeve of the crankshaft seal group must not be used if the seal and the sleeve have been separated. | |||
| A | - | - | Distance from the sleeve to the seal is |
| C | - | - | Installation depth of the sleeve from the rear face of the crank shaft is |
Caterpillar Information System:
C27 and C32 Industrial and Petroleum Engines Flywheel Housing
C27 and C32 Tier 4 Engines Flywheel Housing
C175-16 Locomotive Engine Fuel Lines - Fuel Lines for the High Pressure Fuel Pump
2007/10/29 Improved Securing of the Wiring Harness {1408}
C15 and C18 Petrolem Generator Set Engines Component Location
C15 and C18 Petrolem Generator Set Engines Configuration Parameters
G3520B Engine Sensors and Electrical Components
C9 Petroleum Engines Turbocharger
G3520B Industrial Engines Sensor Signal (Analog, Passive) - Test
C15 and C18 Petrolem Generator Set Engines Diagnostic Trouble Codes
G3520B Engine Specifications
G3520B Engine Product Description
G3520B Engine Refill Capacities and Recommendations
2007/10/08 Improved Exhaust Riser Brackets are Now Available {1059, 1154}
2007/10/22 A New Spring Helps to Relieve Combustion Pressure {1550}
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 9, 10, and 11) {5061, 506G, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 9, 10, and 11) {5061, 506G, 5073}
2007/10/01 Improvements for the Engine Oil Cooler Are Now Used {1378, 1380}
2007/10/08 Improvements for the Engine Oil Cooler Are Now Used {1378}
2007/10/01 Improvements for the Engine Oil Cooler Are Now Used {1378}
C15 and C18 Petrolem Generator Set Engines Oil Temperature Is High
3608 Engine Crankshaft Front Seal - Install
3608 Engine Idler Gears (Front) - Remove
3608 Engine Idler Gears (Front) - Install
G3520B Engine Reference Material