CID 0091 FMI 08 Throttle Position signal abnormal
产生此代码的情况:
电子控制模块(ECM)检测到不在控制工作范围内的速度控制脉宽调制信号(PWM)。
注: 请参阅故障诊断与排除, "系统配置参数"以了解与油门控制的输入配置有关的信息。
系统响应:
ECM 将会记录此诊断代码。 油门位置会标为无效数据。
- 如果配置了辅助油门,ECM 会使用辅助油门的信号。
- 如果没有配置其他油门输入,或其他油门输入信号无效,发动机转速会缺省为额定发动机转速。
测试步骤 1. 进行以下的诊断步骤: 转速控制 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
C3.3 and C4.4 Rental Generator Sets Additional Messages
Hose and Coupling Assembly and Repair Process Guide{0684, 3016, 3103, 3154, 4133, 4257, 4304, 5057, 7554} Hose and Coupling Assembly and Repair Process Guide{0684, 3016, 3103, 3154, 4133, 4257, 4304, 5057, 7554}
CX31 and CX31 HT On-Highway Transmissions General Troubleshooting Information
C15 and C18 Generator Set Engines Alternator - Remove and Install
C175 Generator Set Engines Engine Oil Pump - Remove
C15 and C18 Generator Set Engines Electronic Control Module - Remove and Install
3512C and 3516C Engines Starting Motor System
3512C and 3516C Engines Speed Control
2006/04/17 Slide Sledge Heavy Equipment Repair Tools Are Now Available {0599, 0644}
C7 Marine Engines Oil Cooler (Transmission, Auxiliary) - Remove and Install
3512C and 3516C Engines Pulse Width Modulated Sensor
3500 Engines Balancer Group (Front) - Remove and Install - 3508C Engine
C175 Generator Set Engines Engine Oil Pump - Install
C15 and C18 Generator Set Engines Electric Starting Motor - Remove and Install
3512C and 3516C Engines Sensor Supply
C175 Generator Set Engines Air Inlet Manifold - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Belt Tensioner
3512C and 3516C Engines Analog Sensor (Passive)
C175-16 and C175-20 Engines for Caterpillar Built Machines Fuel Pump (High Pressure) - Remove and Install
C15 and C18 Generator Set Engines Fan Drive - Remove
3508C, 3512C and 3516C Marine Engines Engine Oil Sequence Valves - Remove and Install
C3.3 Industrial Engine Air Inlet and Exhaust System - Inspect
C15 and C18 Generator Set Engines Fan Drive - Install
C3.3 Industrial Engine Exhaust Elbow - Remove and Install - If Equipped