Belt Tensioner
Show/hide table
 | |
| 图 1 | g02547197 |
Show/hide table
| 190-0643 皮带张紧器总成 的技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| A | - | - | 最小受限行程为 71 度。 |
| 1 | - | - | 距自由臂位置 36 度处，弹簧的装配扭矩为 47.5 ± 4.3 N·m (35.0 ± 3.2 lb ft)。 |
Caterpillar Information System:
C175 Generator Set Engines Air Inlet Manifold - Remove and Install
3512C and 3516C Engines Sensor Supply
C15 and C18 Generator Set Engines Electric Starting Motor - Remove and Install
C175 Generator Set Engines Engine Oil Pump - Install
C15 and C18 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
C3.3 and C4.4 Rental Generator Sets Additional Messages
Hose and Coupling Assembly and Repair Process Guide{0684, 3016, 3103, 3154, 4133, 4257, 4304, 5057, 7554} Hose and Coupling Assembly and Repair Process Guide{0684, 3016, 3103, 3154, 4133, 4257, 4304, 5057, 7554}
CX31 and CX31 HT On-Highway Transmissions General Troubleshooting Information
C15 and C18 Generator Set Engines Alternator - Remove and Install
C175 Generator Set Engines Engine Oil Pump - Remove
C15 and C18 Generator Set Engines Electronic Control Module - Remove and Install
3512C and 3516C Engines Starting Motor System
3512C and 3516C Engines Analog Sensor (Passive)
C175-16 and C175-20 Engines for Caterpillar Built Machines Fuel Pump (High Pressure) - Remove and Install
C15 and C18 Generator Set Engines Fan Drive - Remove
3508C, 3512C and 3516C Marine Engines Engine Oil Sequence Valves - Remove and Install
C3.3 Industrial Engine Air Inlet and Exhaust System - Inspect
C15 and C18 Generator Set Engines Fan Drive - Install
C3.3 Industrial Engine Exhaust Elbow - Remove and Install - If Equipped
C15 and C18 Generator Set Engines Pump Drive - Remove
C15 and C18 Generator Set Engines Pump Drive - Install
C175 Generator Sets Engine Stopping
C15 and C18 Generator Set Engines Fuel Transfer Pump - Remove
2006/03/20 A New Replacement Kit for the Bezel is Now Used on the Integrated Control Head {1915}