Tools Are Available for the Installation of Crankshaft Seals and Wear Sleeves {0700}
- Marine Engine:
- C32 MARINE (S/N: RNC1-UP)
Six tools are available for the installation of the hydrodynamic seals and the wear sleeves in the above engines. The seal locator assemblies guide the seal groups during installation. The seal installer assemblies drive the seal groups across the locators and into the proper locations.
The 249-2937 Seal Locator As is new. The remaining locators and installers can also be used on C32 Marine Engines and on C27 Industrial Engines. The remaining seal locator assemblies and seal installer assemblies were previously released for use on other models. The following chart provides the part numbers for the tools and the new applications for the tools.
Show/hide table
| Tools for Crankshaft Seal and Wear Sleeve Installationin C27 Industrial Engines and C32 Marine Engines | ||
| Application | Pt. No. for the Seal Locator Assemblies | Pt. No. for the Seal Installer Assemblies |
| Front | 5P-1733 | 6V-6142 |
| Rear | ||
| Small pilot crank gear | 5P-1733 | 6V-6143 |
| Large pilot crank gear | 249-2937 | 6V-6143 |
Caterpillar Information System:
G3408C and G3412C Engines Emergency Stopping
G3408C and G3412C Engines Starting the Engine
G3408C and G3412C Engines Alarms and Shutoffs
C15 and C18 Engines for Caterpillar Built Machines Exhaust Temperature - Test
2004/12/27 Portable Contamination Monitor Group Provides a Lower Cost Alternative to Particle Counting {0781, 0784, 0786, 1300, 5050}
C15 and C18 Engines for Caterpillar Built Machines Aftercooler - Test
C9 Marine Generator Set Engines Air Inlet and Exhaust System
G3520B Industrial Engine ECM Status Indicator Output
G3520B Industrial Engine ECM Output Circuit (Starting Motor)
C9 Marine Generator Set Engines Fuel System
G3520B Industrial Engine ECM Output Circuit (Fuel Control)
2004/12/01 Single Purpose Fluid Sampling Valves and Dual Purpose Fluid Sampling Valves Require Different Quick Connect Couplers {0645, 7542}
C0.5 and C0.7 Industrial Engines Crushing Prevention and Cutting Prevention
G3408 and G3412 Engines Electric Starting Motor
C15 and C18 Engines for Caterpillar Built Machines Fuel System Pressure - Test
3408E and 3412E Engines for Caterpillar Built Machines Fuel Filter Base
General Service and Repair Safety Information Safety Information
C9 Marine Engines and C9 Marine Generator Sets Flywheel
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Pan
2012/08/30 Improved Locknuts for the High Pressure Turbocharger to Exhaust Manifold Joint Are Available for Certain Truck Engines {1052}
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
C27 and C32 Engines Piston Ring Groove - Inspect
G3520B Industrial Engine Engine Speed/Timing Sensor
TK711, TK721, TK722 and TK732 Track Feller Bunchers Seat