CID 0190 FMI 11 Engine Speed Sensor mechanical failure
产生此代码的情况:
电子控制模块（ECM）可检测以下状况：
- 主发动机转速 / 正时传感器的正时环齿形丢失超过一秒钟。
- 辅助发动机转速 / 正时传感器的信号良好
系统响应:
ECM 将会记录此诊断代码。 ECM 将使用辅助转速 / 正时传感器。
- 发动机可能缺火并 / 或停机
注: 只有当主发动机转速 / 正时传感器和辅助发动机转速 / 正时传感器发生故障时，发动机才会停机。
测试步骤 1. 进行以下的诊断步骤: 发动机转速 / 正时传感器电路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
3406E Marine Engine Auxiliary Water Pump - Assemble - Type 1
3306B-XQ200 Rental Generator Set Engine Trailer - Inspect
3306B-XQ200 Rental Generator Set Engine Battery or Battery Cable - Disconnect
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0164 FMI 11 Injector Actuation Pressure system fault
C11 and C13 Engines for Caterpillar Built Machines CID 0091 FMI 08 Throttle Position signal abnormal
G3304 and G3306 Engines Main Bearings - Inspect
Electrical Connections for the G3600A+ Customer Connectors{7426} Electrical Connections for the G3600A+ Customer Connectors{7426}
G3406 Engine Measuring Inlet Manifold Pressure
3500 Engines for Caterpillar Built Generator Sets Gear Group (Rear)
3306B-XQ200 Rental Generator Set Engine XQ Rental Generator Set Support
3406E Marine Engine Auxiliary Water Pump - Disassemble - Type 1
3406E Marine Engine Auxiliary Water Pump - Install
3306B-XQ200 Rental Generator Set Engine Wiring Diagrams
Installation and Calibration of the 144-0441 Tachometer {7462} Installation and Calibration of the 144-0441 Tachometer {7462}
C11 and C13 Engines for Caterpillar Built Machines CID 0286 FMI 05 EMS Oil Lamp open/short to ground
C11 and C13 Engines for Caterpillar Built Machines CID 0286 FMI 06 EMS Oil Lamp short to +batt
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0617 FMI 05 Air Inlet Heater Relay open/current below normal
C-9 Industrial Engine System Configuration Parameters
3406E and C15 Marine Engines Aftercooler - Remove
Product Identification Numbers (PIN) Location Guide Wheel Loader
PM3516 Power Modules Plate Locations and Film Locations
2001/04/01 The Nomenclature For The 3126 Series Truck Engines Will Change From 3126B To 3126E {1000}
2001/03/01 New Stainless Steel Bolts Are Used In The Aftercooler Housing {1071}
2001/03/01 A New Plastic Belt Guard Is Available {1357}