Battery or Battery Cable - Disconnect
Show/hide table
 |
|
The battery cables or the batteries should not be removed with the battery cover in place. The battery cover should be removed before any servicing is attempted. Removing the battery cables or the batteries with the cover in place may cause a battery explosion resulting in personal injury. |
- Turn the start switch to the OFF position. Turn the battery disconnect switch to the OFF position and remove the key and all electrical loads.
- Disconnect the negative battery terminal at the battery that goes to the start switch. Ensure that the cable cannot contact the terminal. When four 12 volt batteries are involved, the negative side of two batteries must be disconnected.
- Tape the leads in order to help prevent accidental starting.
- Proceed with necessary system repairs. Reverse the steps in order to reconnect all of the cables.
Caterpillar Information System:
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0164 FMI 11 Injector Actuation Pressure system fault
C11 and C13 Engines for Caterpillar Built Machines CID 0091 FMI 08 Throttle Position signal abnormal
G3304 and G3306 Engines Main Bearings - Inspect
Electrical Connections for the G3600A+ Customer Connectors{7426} Electrical Connections for the G3600A+ Customer Connectors{7426}
G3406 Engine Measuring Inlet Manifold Pressure
3500 Engines for Caterpillar Built Generator Sets Gear Group (Rear)
3306B-XQ200 Rental Generator Set Engine XQ Rental Generator Set Support
3406E Marine Engine Auxiliary Water Pump - Disassemble - Type 1
3406E Marine Engine Auxiliary Water Pump - Install
G3406 Engine Measuring Inlet Manifold Temperature
3500B Marine Engines Electrical Power Supply
3406E Marine Engine Auxiliary Water Pump - Remove
3306B-XQ200 Rental Generator Set Engine Trailer - Inspect
3406E Marine Engine Auxiliary Water Pump - Assemble - Type 1
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0190 FMI 11 Engine Speed Sensor mechanical failure
3306B-XQ200 Rental Generator Set Engine Wiring Diagrams
Installation and Calibration of the 144-0441 Tachometer {7462} Installation and Calibration of the 144-0441 Tachometer {7462}
C11 and C13 Engines for Caterpillar Built Machines CID 0286 FMI 05 EMS Oil Lamp open/short to ground
C11 and C13 Engines for Caterpillar Built Machines CID 0286 FMI 06 EMS Oil Lamp short to +batt
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0617 FMI 05 Air Inlet Heater Relay open/current below normal
C-9 Industrial Engine System Configuration Parameters
3406E and C15 Marine Engines Aftercooler - Remove
Product Identification Numbers (PIN) Location Guide Wheel Loader
PM3516 Power Modules Plate Locations and Film Locations