Water Lines
Show/hide table
 | |
| Illustration 1 | g00761473 |
(1) Tighten the water temperature sensor to the following torque. ... 20 ± 3 N·m (15 ± 2 lb ft)
(2) Lubricate the bore for the seal with a small amount of glycerin.
Caterpillar Information System:
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Sensor Open/Short Test
C-10 and C-12 Industrial Engines Air Inlet and Exhaust System
3126B Industrial Engine Vibration Damper and Pulley - Remove and Install
3126B Industrial Engine Belt Tightener - Remove
3126B Industrial Engine Belt Tightener - Install
3126B Industrial Engine Engine Oil Pan - Remove and Install
3126B Industrial Engine Air Inlet Heater - Remove and Install
3126B Industrial Engine Fuel Filter Base - Remove and Install
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Emergency Stop Switch
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets ECM/Personality Module
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Digital Sensor Supply
C-15 and C-16 Industrial Engines Engine Oil Pan
C-10 and C-12 Industrial Engines Lubrication System
3126B Industrial Engine Water Pump - Assemble
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054 Engine Cylinder Head - Inspect
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor
3126B Industrial Engine Engine Oil Pressure Sensor - Test
3126B Industrial Engine Water Pump - Install
3054 Engine Engine Oil Pump - Inspect
3126B Industrial Engine Vibration Damper
C4.4 Industrial Engine Fuel Conservation Practices
3126B Industrial Engine Turbocharger - Install