3406E On-Highway Engine Caterpillar


Fuel Temperature Sensor - Remove and Install

Usage:

3406E 1MM

Removal Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g00621466
    Typical example

  1. Disconnect fuel temperature sensor (1) from the engine wiring harness.

  2. Remove fuel temperature sensor (1).

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 2g00621466
    Typical example

  1. Install fuel temperature sensor (1). Tighten the sensor to a torque of 20 ± 5 N·m (15 ± 4 lb ft).

  2. Connect fuel temperature sensor (1) to the engine wiring harness.

Caterpillar Information System:

3406E, C-10, C-12, C-15, C-16 Truck Engines Serial Number Plate
26SI Series Alternator Component Description
3406E On-Highway Engine Engine Support (Front) - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines Schematics and Wiring Diagrams
3512B Marine Auxiliary Engine Low RPM Indicator
C-15, C-16 and C-18 Truck Engines Accessory Drive - Assemble
26SI Series Alternator General Information
3512B Marine Auxiliary Engine Permanent Timing Calibration Sensor
3524B Engine for Caterpillar Built Machines Crankshaft Rear Seal and Wear Sleeve - Install
26SI Series Alternator Alternator
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Crankshaft Front Seal and Wear Sleeve - Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Crankshaft Front Seal and Wear Sleeve - Remove
3406E On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
3406E On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
3406E On-Highway Engine Boost Pressure Sensor - Remove and Install
3512B Marine Auxiliary Engine Cooling System Operation
On-Highway Engines Electronic PTO Installation and Application Guide Switches
26SI Series Alternator Normal Operation
3512B Marine Auxiliary Engine Before Starting Engine
3512B Marine Auxiliary Engine Fuel Conservation Practices
26SI Series Alternator T1 Alternator Output - Test
26SI Series Alternator T2 Electrical System Current - Test
26SI Series Alternator T3 Charging System - Test
26SI Series Alternator T4 Alternator Drive System - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.