797 ATTACHMENT CODES (A And B Models)     | |||
Attachment Code     | Fuel Tank # (1) (2) (3)     |
RAC Enabled     | TKPH Enabled     |
1     | 1     | No     | No     |
2     | 2     | No     | No     |
3     | 3     | No     | No     |
41     | 1     | Yes     | No     |
42     | 2     | Yes     | No     |
43     | 3     | Yes     | No     |
51     | 1     | No     | Yes     |
52     | 2     | No     | Yes     |
53     | 3     | No     | Yes     |
61     | 1     | Yes     | Yes     |
62     | 2     | Yes     | Yes     |
63     | 3     | Yes     | Yes     |
( 1 ) | 1000 gallon |
( 2 ) | 1600 gallon |
( 3 ) | 1800 gallon/1350 gallon |
785-793 ATTACHMENT CODES (C Models)     | ||
Attachment Code     | RAC Enabled     | TKPH Enabled     |
0     | No     | No     |
4     | Yes     | No     |
5     | No     | Yes     |
6     | Yes     | Yes     |
The following information describes the service program code: 288224 (ATTACH)
This service program allows the operator to configure the attachment code. The Attachment Code is the software version of the Harness Code. The harness code is a hard wired configuration of jumper wires that ground certain circuits in a harness code plug. The VIMS broadcasts the attachment code via the Cat Data Link to other electronic control modules on the machine that need this code.
注: Applicable attachment codes are listed on the back of machine Electrical Schematic and in the Operations and Maintenance Manual.
注: VIMSpc must be connected to the machine In order to change the 288224 (ATTACH) code.
After 288224 ATTACH is entered from the keypad, the operator presses the "OK" key. The message center will show:
图 1 | g00485847 |
The desired attachment code can then be entered from the keypad by entering the desired attachment code. Then press the "OK" key. If a valid attachment code has been entered, the message center will prompt the operator to re-enter the attachment code. The message center will show:
图 2 | g00485848 |
If the same code is entered again, this code will be accepted as the new attachment code. If the same code is not entered at the second prompt, the new attachment code will not be accepted. The old attachment code remains valid. A new attachment code will not be accepted, if an invalid code is entered at either prompt. The old attachment code remains valid. If the "OK" key was pressed at either prompt prior to entering a number, the old attachment code remains valid.
注: The Machine Status (MSTAT) (67828) code can be used to view the present, active attachment code. Entering an invalid code will take the user back to the main screen.