 | |
| Illustration 1 | g00485881 |
Input Transfer Gears (1) Shims (2) Drive gear (3) Bearing cup and cone (4) Seal (5) Bearing cup and cone (6) Yoke assembly (7) Cage (8) Cage (9) Seal (10) Bearing cup and cone (11) Gear (12) Plate (13) Bearing cup and cone (14) Bolts (15) Gasket (16) Shims | |
The input transfer gears are used to connect the torque converter to the transmission. The input transfer gears are connected to the torque converter by the upper drive shaft. Yoke assembly (6) connects the upper drive shaft to the input transfer gears. The input transfer gears are connected to the transmission by gear (11). Gear (11) is connected to the input shaft of the transmission.
Power flows through yoke assembly (6) to drive gear (2). Power then flows from drive gear (2) to driven gear (11) to the transmission input shaft.
Shims (1) are used to make an adjustment to the end play (bearing preload) of gear (2). Shims (16) are used to make an adjustment to the end play (bearing preload) of gear (11). For the proper adjustment procedures, refer to Systems Operation/Testing and Adjusting, "Transfer Gear (Input) - Adjust)".
Input Transfer Gear Lubrication
The input transfer gears get lubrication oil from the transmission planetary. Two passages in the No. 1 clutch housing send oil to the transfer gears. Each passage sends oil to one of the input gears.